E1993A Datasheet, PDF (32/40 Pages) Keysight Technologies – W-CDMA Mobile Test Application

32 | Keysight | E1963A W-CDMA Mobile Test Application - Technical Overview
RF analyzer
Measurement input frequency ranges
698 to 1000 MHz
1400 to 1500 MHz
1700 to 1990 MHz
2480 to 2580 MHz
Frequency ranges for uplink channels (MHz)
Band I (IMT-2000)
1922.4 to 1977.6
Band II (US PCS)
1852.4 to 1907.6
Band III (DCS/PCS)
1712.4 to 1782.6
Band IV
1712.4 to 1752.6
Band V (US Cellular)
826.4 to 846.6
Band VI (Japan 800)
832.4 to 837.6
Band VII (UMTS 2600)
2502.4 to 2567.6
Band VIII (UMTS 900)
882.4 to 912.6
Band IX (UMTS 1700)
1752.4 to 1782.4
Band X (UMTS Extended)
1712.4 to 1767.6
Band XI (UMTS 1500)
1430.4 to 1450.4
Band XII (UMTS 700)
698 to 716
Band XIII (UMTS 700)
777 to 787
Band XIV (UMTS 700)
788 to 798
Band XIX
832.4 to 842.6
Band XX
834.4 to 859.6
Band XXI
1450.4 to 1460.4
Frequency/Channel setting: By channel number or MHz (test mode only)
http://wireless.keysight.com/rfcomms/refdocs/wcdma/wcdma_gen_bse_ul_chan_num.html
Input level setting range: –70 to +30 dBm/3.84 MHz
Receiver ranging:
–– Auto (Active closed loop power control): The test set uses TPC commands to the UE to
adjust its transmit power as needed to achieve the “UE Target Power”
–– Manual mode: User enters expected power; provides calibrated results if actual power is
within ±9 dB of the user-entered level
Demodulation chip rate: 3.84 Mcps
Maximum input level: +37 dBm peak (5 W peak)
Amplitude scaling: Settable from 0.1 to 20 dB/division in 0.1 dB steps