N1055A Datasheet, PDF (6/19 Pages) Keysight Technologies – 35/50 GHz 2/4 Port TDR/TDT For the 86100D DCA-X Series Oscilloscope Mainframe

06 | Keysight | N1055A Remote Head Module 35/50 GHz 2/4 Port TDR/TDT - Data Sheet
Adjustable effective TDR rise time
Standards typically specify 10 to 90% or 20 to 80% edge speeds
to be used for compliant measurements. FlexDCA makes it easy
to control the effective rise time of the stimulus pulse so users
can perform compliant measurements.
Ultra-slim remote heads optimize signal fidelity
The industry’s lightest and smallest remote TDR heads allow
direct connection to the device under test using a TDR/TDT step
generator and low-noise sampler located at the end of a flexible
1.6-meter phase-stable cable. This ensures optimal step fidelity
and minimizes signal degradation due to adapters or cables.
Remote heads can be configured with male or female connectors
to further minimize the number of adapters used in the system.
Adjustable effective TDR rise time ensures compliant measurements.
Single-ended and differential stimulus
The TDR/TDT remote heads may
be configured for single-ended,
differential or common-mode
measurements with True-Mode
or Mixed-Mode stimulus.
Step polarity, skew, amplitude
and repetition rate can also be
configured.
The industry’s smallest TDR/TDT remote heads optimize signal fidelity.
Two remote heads form a differential pair; heads may be held
together using a remote head clamp (two clamps are shipped
with each module). When clamped, pin-to-pin spacing is 10 mm.
The ultra-thin remote head has also been designed so it can
be directly connected to most high-bandwidth TDR probes on
the market today, thereby minimizing signal degradation due to
cables.
Ultra-thin remote heads connect directly to TDR probes or may be
clamped together to form a differential pair (clamp included).
An easy-to-use graphical user interface simplifies single-ended and
differential device setup.