N1914A Datasheet, PDF (10/28 Pages) Keysight Technologies – EPM Series Power Meters E-Series and 8480 Series Power Sensors

10 | Keysight | N1913A and N1914A EPM Series Power Meters / E-Series and 8480 Series Power Sensors - Data Sheet
N1913A/14A EPM Series Power Meters Performance Characteristics (continued)
Line power
Input voltage range
90 to 264 VAC, automatic selection
Input frequency range
47 to 63 Hz and 400 Hz @ 110 Vac)
Power requirement
75 VA (50 Watts)
Battery option operational characteristics¹
The following information describes characteristic performance based at a temperature of 25 °C unless otherwise noted.
Typical operating time
Up to 6 hours with LCD backlight on; up to 7.5 hours with LCD backlight off (N1913A power meter).
Charge time
Approximately, 2.5 hours to charge fully from an empty state. Power meter is operational whilst charging.
Battery type
Lithium-ion (Li-ion)
Battery storage temperature
–20 °C to 60 °C, ≤ 80 % RH
Environmental characteristics
Electromagnetic compatibility
Complies with the essential requirements of EMC Directive (2004/108/EC) as follows:
IEC61326- 1:2005 / EN61326- 1:2006
CISPR11:2003 / EN55011:2007 (Group 1, Class A)
The product also meets the following EMC standards:
Canada: ICES/NMB- 001:2004
Australia/New Zealand: AS/NZS CISPR 11:2004
Product safety
This product conforms to the requirements of the following safety standards:
IEC 61010- 1:2001 / EN 61010- 1:2001
CAN/CSA- C22.2 No.61010- 1- 04
ANSI/UL61010- 1:2004
Low Voltage Directive
This product conforms to the requirements of European Council Directive “2006/95/EC”
Operating environment
Temperature
0 °C to 55 °C
Maximum humidity
95% at 40 °C (non-condensing)
Maximum altitude
4,600 meters (15,000 feet)
Storage conditions
Non-operating storage temperature
–40 °C to +70 °C
Non-operating maximum humidity
90% at 65 °C (non-condensing)
Non-operating maximum altitude
4,600 meters (15,000 feet)
Remote programming
Interface
GPIB, USB and LAN interfaces operates to IEEE 488.2 standard
Command language
SCPI standard interface commands. Code-compatible with legacy E4418B/9B EPM Series, 436A, 437B
and 438A power meters (43X compatibility only with option N191xA-200).
GPIB compatibility
SH1, AH1, T6, TE0, L4, LE0, SR1, RL1, PP1, DC1, DT1, C0
1.  Characteristics describe product performance that is useful in the application of the product, but is not covered by the product warranty.