IA8044 Datasheet, PDF (5/49 Pages) InnovASIC, Inc – SDLC COMMUNICATIONS CONTROLLER

IA8044/IA8344
SDLC COMMUNICATIONS CONTROLLER
Data Sheet
Memory Organization
Program Memory
Program Memory includes interrupt and Reset vectors. The interrupt vectors are spaced at 8-
byte intervals, starting from 0003H for External Interrupt 0.
Reset Vectors
Location
0003H
000BH
0013H
001BH
0023H
Service
External Interrupt 0
Timer 0 overflow
External Interrupt 1
Timer 1 overflow
SIU Interrupt
These locations may be used for program code, if the corresponding interrupts are not used
(disabled). The Program Memory space is 64K, from 0000H to FFFFH. The lowest 4K of program
code (0000H to 0FFFH) can be fetched from external or internal Program Memory. This selection is
made by strapping pin ‘EA’ (External Address) to GND or VCC. If during reset, ‘EA’ is held low,
all the program code is fetched from external memory. If, during reset, ‘EA’ is held high, the lowest
4K of program code (0000H to 0FFFH) is fetched from internal memory (ROM). Program
memory addresses above 4K (0FFFH) will cause the program code to be fetched from external
memory regardless of the setting of ‘EA’.
Data Memory
External Data Memory
The IA8044/IA8344 Microcontroller core incorporates the Harvard architecture, with separate
code and data spaces. The code from external memory is fetched by ‘psen’ strobe, while data
is read from RAM by bit 7 of P3 (read strobe) and written to RAM by bit 6 of P3 (write strobe). The
External Data Memory space is active only by addressing through use of the MOVX instruction and
the 16-bit Data Pointer Register (DPTR). A smaller subset of external data memory (8 bit
addressing) may be accessed by using the MOVX instruction with register indexed addressing.
Internal Data Memory
The Internal Data Memory address is always 1 byte wide. The memory space is 192 bytes
large (00H to BFH), and can be accessed by either direct or indirect addressing. The Special
Function Registers occupy the upper 128 bytes. This SFR area is available only by direct
addressing. Internal memory that overlaps the SFR address space is only accessible by indirect
addressing.
Copyright © 2003
innovASIC
The End of Obsolescence™
ENG210010112-00
Page 5 of 49
www.innovasic.com
Customer Support:
1-888-824-4184