TC1784 Datasheet, PDF (56/123 Pages) Infineon Technologies AG – 32-Bit Single-Chip Microcontroller

TC1784
Electrical ParametersGeneral Parameters
5.1.5 Operating Conditions
The following operating conditions must not be exceeded in order to ensure correct
operation and reliability of the TC1784. All parameters specified in the following tables
refer to these operating conditions, unless otherwise noticed.
Digital supply voltages applied to the TC1784 must be static regulated voltages which
allow a typical voltage swing of ± 5 %.
All parameters specified in the following tables (Table 11 and following) refer to these
operating conditions (Table 9), unless otherwise noticed in the Note / Test Condition
column.
The Extended Range Operating Conditions did not increase area of validity of the
parameters defined in table 9 and later.
Table 9
Operating Conditions Parameters
Parameter
Symbol
Values
Unit Note /
Min. Typ. Max.
Test Condition
Overload coupling factor K_OVAN −
−
0.0001
for analog inputs, negative CC
I_OV≤ 0 mA;
I_OV≥ -2 mA;
analog
pad= 5.0 V
Overload coupling factor K_OVAP −
−
0.0000
for analog inputs, positive CC
1
I_OV≤ 3 mA;
I_OV≥ 0 mA;
analog
pad= 5.0 V
CPU Frequency
f_CPU SR −
−
FPI bus frequency
f_FPI SR −
−
LMB frequency
f_LMB CC −
−
PCP Frequency
f_PCP SR −
−
Inactive device pin current I_ID SR -1
−
180 MHz
90
MHz
180 MHz
180 MHz
1
mA All power
supply
voltagesV_DDx =
0
Short circuit current of
I_SC SR -5
−
5
mA
digital outputs¹⁾
Absolute sum of short
ΣI_{SC_D} −
−
100 mA
circuit currents of the
CC
device
Data Sheet
49
V 1.1.1, 2014-05