TC1784 Datasheet, PDF (122/123 Pages) Infineon Technologies AG – 32-Bit Single-Chip Microcontroller

TC1784
History
6
History
The Version 0.7 is the first version of this document:
The following changes where done between Version 0.7 and 0.71 of this document:
• update and coorect figure 3-2
• update and correct table 3-1
The following changes where done between Version 0.71 and 1.0 of this document:
• adapt Absolute Maximum Rating
• clarify pad supply levels in Pin Reliability in Overload section
• add note at the end of Pin Reliability in Overload section
• clarify wording for valid operating conditions
• split FADC DNL parameter into two conditions and change value for gain 4 and 8
• add footnote 5 to I_DDP
• add footnote for D-Flash currents in power section
• rework first sentence for chapter 5.3
• reduce min value for t_L for both PLLs
• add for MLI and SSC timing parameter: valid strong driver medium edge only
• change MLI parameter t₁₇ min value
• update parameter description for SSC parameters t₅₂, t₅₃, t₅₆, t₅₇, t₅₈, and t₅₉
• change SSC parameters from CC to SR Symbol for t₅₆, t₅₇, t₅₈ and t₅₉
• add footnote to Flash parameter t_ERD
The following changes where done between Version 1.0 and 1.1 of this document:
• remove the following product options:
– SAK-TC1784N-320F180EL
• add the following product options:
– SAK-TC1784F-320F180EP
• change t₄₈ from 100ns to 200ns in table 42
• change t₄₉ from 100ns to 200ns in table 42
• extend K_OVAN conditon from I_OV≤ 0 mA; I_OV≥ -1 mA to I_OV≤ 0 mA; I_OV≥ -2 mA
• change parameter EF_OFF from +-90mV to +-120 for condition Calibration = No
• change package version from PG-LFBGA-292-3 to PG-LFBGA-292-6
The following changes where done between Version 1.1 and 1.1.1 of this document:
• change parameter EF_OFF from +-120mV to +-90 for condition Calibration = No
Data Sheet
115
V 1.1.1, 2014-05