TLE8110EE_13 Datasheet, PDF (44/74 Pages) Infineon Technologies AG – Overvoltage, Overtemperature, ESD -Protection

TLE 8110 EE
Smart Multichannel Switch
Control of the device
12
Control of the device
This chapter describes the SPI-Interface signals, the protocol, registers and commands. Reading this chapter
allows the Software Engineer to control the device. The chapter contains also some information about
communication safety features of the protocol.
12.1
Internal Clock
The device contains an internal clock oscillator.
Electrical Characteristics: Internal Clock
3.0V < V_CC < 5.5V; 4.5V < V_DD < 5.5V, T_j = -40°C to +150°C, all voltages with respect to ground, positive current
flowing into pin
(unless otherwise specified)
Pos. Parameter
Symbol
Limit Values
Unit Conditions
Min. Typ. Max.
Parallel Inputs
12.1.1 internal clock oscillator frequency f_{int_osc}
-
500 -
kHz ¹⁾
1) Parameter not subject to production test. Specified by design.
12.2
12.2.1
SPI Interface. Signals and Protocol
Description 16 bit SPI Interface Signals
S_CS - Chip Select:
The system micro controller selects the TLE8110EE by means of the S_CS pin. Whenever the pin is in low state,
data transfer can take place. When S_CS is in high state, any signals at the S_CLK and S_SI pins are ignored
and S_SO is forced into a high impedance state.
S_CS High to Low transition:
• The information to be transferred loaded into the shift register (16-bit Protocol).
•
S_CS Low to High transition:
• Command decoding is only done, when after the falling edge of CS exactly a multiple (1, 2, 3, …) of eight
S_CLK signals have been detected. (See Modulo-8 Counter: Chapter 12.2.4.2)
Data Sheet
44
Rev. 1.4, 2013-07-02