TC1793 Datasheet, PDF (187/189 Pages) Infineon Technologies AG – 32-Bit Single-Chip Microcontroller

TC1793
History
• add note at the end of Pin Reliability in Overload section
• clearify pad supply levels in Pin Reliability in Overload section
• add footnote for D-Flash currents in power section
• clearify wording for valid operating conditions
• add negative limit for class S pad leakage
• increase max values for parameter t_B
• change formula 10
• change MLI parameter t₁₇ min value
• change footnote 3 for EBU parameter t₂₂
• change package naming
• add products SAK-TC1793N-512F270EF and SAK-TC1793N-512F270EB
• split FADC DNL parameter into two conditions and change value for gain 4 and 8
• update footnote 10 for the ADC
• update package outline
• update parmeter description for SSC parameters t₅₂ and t₅₃
• change SSC parameters from CC to SR Symbol for t₅₆, t₅₇, t₅₈ and t₅₉
• increase value range for BFCLKO duty cycle
The following changes where done between Version 1.0 and 1.1 of this document:
• add product option SAK-TC1793S-512F270EF
• update block diagrams to cover new option
• add identification registers for new product option
• rework first sentence for chapter 5.3
• reduce min value for t_L for both PLLs
• split f_VCO for system PLL into two conditions
• add for MLI and SSC parameter: valid strong driver medium edge only
• add footnote 5) for SSC parameters
• add parameters t₁₅, t₁₆, t₁₇, and t₁₉ to the EBU
The following changes where done between Version 1.1 and 1.1.1 of this document:
• update the incoorect CHIPID values for copper and non copper bond options.
• product SAK-TC-1793N-512F270EB not longer supported and replaced by SAK-
TC1793N-512F270EF
The following changes where done between Version 1.1.1 and 1.2 of this document:
• remove the following product options:
– SAK-TC1793F-512F270EB
• change V_ILS from 2.1V to 1.9V in table 23
• change t₄₈ from 100ns to 200ns in table 42
• change t₄₉ from 100ns to 200ns in table 42
• extend K_OVAN conditon from I_OV≤ 0 mA; I_OV≥ -1 mA to I_OV≤ 0 mA; I_OV≥ -2 mA
• change t₈ from -4ns to -2ns in table 43
• change t₁₈ from -4ns to -2ns in table 43
Data Sheet
4
V 1.2, 2014-05