TC1793 Datasheet, PDF (185/189 Pages) Infineon Technologies AG – 32-Bit Single-Chip Microcontroller

TC1793
History
• add output function TData1 for MLI1 as O3 for P8.3
• remove O2 OUT105 for GPTA1 of P14.9
• add O2 T3OUt for GPT121 of P14.9
• changed the name for O3 from EVTO2 to EVTO1 for P0.5
• changed the name for O3 from EVTO3 to EVTO2 for P0.6
• changed the name for O3 from EVTO4 to EVTO3 for P0.7
• changed the name for O1 and O2 from OUT70 to OUT71 for P1.15
• add input function SLSI2 for SSC2 to P4.9
• change input function T13HRE from CCU60 to CCU63 for P3.14
• change for port 8.2 the symbol from CC61(CCU60) to COUT63(CCU61)
• change for port 14.10 the symbol from T3OUT(GPT120) to T6OUT(GPT121)
• add to all SSC signal the associated SSC module where is was missing in the pinning
• add section Pin Reliability in Overload
• increase values for absolute maximum parameters I_IN and SumI_IN
• correct P14.8 O2 as this was uncorrected label as O1
The following changes where done between Version 0.63 and 0.7 of this document:
• update value of RTID registers in section Identification Registers for AB step
• remove sentence ‘Exposure to conditions within the maximum ratings will not affect
device reliability. To replace this sentence section Pin Reliability in Overload was
added.
• add footnote 1 to table 12 (Operating Conditions)
• increase values for absolute maximum parameters I_IN and SumI_IN
• remove capacitance conditions for LVDS pad parameters as loads are defined by
interface (MSC) timings
• add parameter V_ILSD for class S pads
• add V_DDM supply limitation for class S parameters
• add footnote 10 to table 23 (ADC parameters)
• remove old footnote 2 from table 24 (FADC parameters)
• remove term typical from load of Peripheral Timings
• add definition of driver strength settings for ERAY Interface Timing
• update formulas for frequency modulation
• change SSC parameter from t₅₉ CC to SR
• add figures for EBU Multiplexer and Demultiplexed Write Access
• change footnote 4 wording for ERAY timing back to TC1797 wording
• increase flash parameters t_PRD and t_PRP values
• increase flash parameter t_ERD
• add section 5.2.6.1.
• change in legende of table 2 definition of class S pad
• remove condition for V_DDEBU
• correct section Extended Range Operating Conditions for the 3.3 V area
• increase limit in Extended Range Operating Conditions from 1 hour to 1000 hours
Data Sheet
2
V 1.2, 2014-05