XC164KM Datasheet, PDF (14/62 Pages) Infineon Technologies AG – 16-Bit Single-Chip Microcontroller with C166SV2 Core

XC164KM
Derivatives
General Device Information
Table 2-1 Pin Definitions and Functions (cont’d)
Sym- Pin Input Function
bol
Num. Outp.
PORT1 1-6, IO
49-56
P1L.7 56
I/O
P1H.0 1
I
I/O
P1H.1 2
I
I/O
P1H.2 3
I
I/O
P1H.3 3
I
I/O
I
P1H.4 5
I/O
I
P1H.5 6
I/O
I
PORT1 consists of one 8-bit and one 6-bit bidirectional I/O
port P1L and P1H. Each pin can be programmed for input
(output driver in high-impedance state) or output.
The following PORT1 pins also serve for alt. functions:
CC22IO [CAPCOM2] CC22 Capture Inp./Compare Outp.
EX0IN [Fast External Interrupt 0] Input (default pin),
CC23IO [CAPCOM2] CC23 Capture Inp./Compare Outp.
EX1IN [Fast External Interrupt 1] Input (default pin),
MRST1 [SSC1] Master-Receive/Slave-Transmit In/Out.
EX2IN [Fast External Interrupt 2] Input (default pin),
MTSR1 [SSC1] Master-Transmit/Slave-Receive Out/Inp.
T7IN [CAPCOM2] Timer T7 Count Input,
SCLK1 [SSC1] Master Clock Output / Slave Clock Input,
EX3IN [Fast External Interrupt 3] Input (default pin),
CC24IO [CAPCOM2] CC24 Capture Inp./Compare Outp.,
EX4IN [Fast External Interrupt 4] Input (default pin)
CC25IO [CAPCOM2] CC25 Capture Inp./Compare Outp.,
EX5IN [Fast External Interrupt 5] Input (default pin)
Note: At the end of an external reset P1H.4 and P1H.5 also
may input startup configuration values
XTAL2 61
O
XTAL1 60
I
XTAL2: Output of the oscillator amplifier circuit
XTAL1: Input to the oscillator amplifier and input to
the internal clock generator
To clock the device from an external source, drive XTAL1,
while leaving XTAL2 unconnected. Minimum and maximum
high/low and rise/fall times specified in the AC
Characteristics must be observed.
V_DDI
26, 58 -
Digital Core Supply Voltage (On-Chip Modules):
+2.5 V during normal operation and idle mode.
Please refer to the Operating Condition Parameters
Data Sheet
12
V1.0, 2005-11