STAC9752 Datasheet, PDF (72/95 Pages) Integrated Device Technology – TWO-CHANNEL, 20-BIT, AC’97 2.3 CODECS WITH HEADPHONE DRIVE, SPDIF OUTPUT MICROPHONE & JACK SENSING

STAC9752/9753
TWO-CHANNEL, 20-BIT, AC’97 2.3 CODECS WITH HEADPHONE DRIVE, SPDIF OUTPUT MICROPHONE & JACK SENSING
8.4.5.
Function Information (68h Page 01h)
Register 24h must be set to Page 01h to access this register.
Default: 00xxh, see table 22: page73.
D15
D14
D13
D12
D11
D10
D9
D8
G4
G3
G2
G1
G0
INV
DL4
DL3
D7
D6
D5
D4
D3
D2
D1
D0
DL2
DL1
DL0
IV
RESERVED
FIP
Bit(s) Reset Value
15
0
14-11
0
10
9-5
Name
G4
G3:G0
INV
DL4:DL0
Description
Gain Sign Bit: The CODEC updates this bit with the sign of the gain value
present in G[3:0]. The BIOS updates this to take into consideration external
amplifiers or other external logic when relevant.
G[4] indicates whether the value is a gain or attenuation.
Gain in the G4 bit is in terms of dB.
This bit is Read/Write and is only reset on POR and not by RESET#.
Gain Bits: The CODEC updates these bits with the gain value (db relative to
level-out) in 1.5dBV increments. The BIOS updates these to take into
consideration external amplifiers or other external logic when relevant.
G[0:3] indicates the magnitude of the gain. G[4] indicates whether the value is a
gain or attenuation.
For Gain/Attenuation settings, see Table 23: page73.
These bits are read/write and are not reset on RESET#.
Inversion bit: Indicates that the CODEC presents a 180 degree phase shift to the
signal.
0h - No inversion reported
1h - Inverted
This bit is read/write and is not reset on RESET#.
BIOS should invert for each inverting gain stage.
Buffer delays: CODEC will provide number a delay measurement for the input
and output channels. Software will use this value to accurately calculate audio
stream position with respect to what is been reproduced or recorded. These
values are in 20.83 µs (1/48000 second) units.
For output channels, this timing is from the end of AC Link frame in which the
sample is provided, until the time the analog signal appears at the output pin. For
input streams, this is from when the analog signal is presented at the pin until the
representative sample is provided on the AC Link.
Analog in and out paths are not considered as part of this delay.
The measurement is a “typical” measurement, at a 48 KHz sample rate, with
minimal in-CODEC processing (i.e., 3D effects are turned off.)
00h - Information not provided
01h…1Eh - Buffer delay in 20.83 µs units
1Fh - reserved
These bits are read/write and are not reset on RESET#.
The default value is the delay internal to the CODEC. The BIOS may add to this
value the known delays external to the CODEC, such as for an external
amplifier.
IDT™
72
STAC9752/9753
TWO-CHANNEL, 20-BIT, AC’97 2.3 CODECS WITH HEADPHONE DRIVE, SPDIF OUTPUT MICROPHONE & JACK SENSING
REV 3.3 1206