7132SA100J Datasheet, PDF (3/16 Pages) Integrated Device Technology – HIGH SPEED 2K x 8 DUAL PORT STATIC RAM

IDT7132SA/LA and IDT 7142SA/LA
High Speed 2K x 8 Dual Port Static RAM
Pin Configurations^(1,2,3) (con't.)
Military, Industrial and Commercial Temperature Ranges
NOTES:
1. All VCC pins must be connected to the power supply.
2. All GND pins must be connected to the ground supply.
3. Package body is approximately .75 in x .75 in x .17 in.
4. This package code is used to reference the package diagram.
5. This text does not indicate orientation of the actual part-marking.
Absolute Maximum Ratings⁽¹⁾
Symbol
Rating
Commercial
& Industrial
Military
Unit
VTERM⁽²⁾
Terminal Voltage
with Respect
to GND
-0.5 to +7.0 -0.5 to +7.0 V
TBIAS
Temperature
Under Bias
-55 to +125 -65 to +135 ^oC
TSTG
Storage
Temperature
-65 to +150 -65 to +150 ^oC
Recommended Operating
Temperature and Supply Voltage^(1,2)
Grade
Ambient
Temperature
GND
Vcc
Military
-55^OC to+125^OC
0V
5.0V + 10%
Commercial
0^OC to +70^OC
0V
5.0V + 10%
Industrial
-40^OC to +85^OC
0V
5.0V + 10%
NOTES:
2692 tbl 02
1. This is the parameter TA. This is the "instant on" case temperature.
2. Industrial temperature: for specific speeds, packages and powers contact your
sales office.
IOUT
DC Output
Current
50
50
mA _{Recommended DC Operating}
NOTES:
2692 tbl 01
1. Stresses greater than those listed under ABSOLUTE MAXIMUM RATINGS may
Conditions
Symbol
Parameter
Min. Typ. Max. Unit
cause permanent damage to the device. This is a stress rating only and functional
operation of the device at these or any other conditions above those indicated in
VCC Supply Voltage
4.5 5.0 5.5 V
the operational sections of the specification is not implied. Exposure to absolute
GND Ground
0
0
0
V
maximum rating conditions for extended periods may affect reliability.
2. VTERM must not exceed Vcc + 10% for more than 25% of the cycle time or 10ns
VIH Input High Voltage
2.2
____
6.0⁽²⁾
V
maximum, and is limited to < 20mA for the period of VTERM > Vcc + 10%.
VIL Input Low Voltage
-0.5⁽¹⁾
____
0.8
V
NOTES:
1. VIL (min.) = -1.5V for pulse width less than 10ns.
2. VTERM must not exceed Vcc + 10%.
2692 tbl 03
6.342