IC-LNB_13 Datasheet, PDF (30/35 Pages) IC-Haus GmbH – 18-BIT OPTO ENCODER WITH SPI AND SER/PAR INTERFACES

iC-LNB 18-BIT OPTO ENCODER ^preliminary
WITH SPI AND SER/PAR INTERFACES
INCREMENTAL OUTPUT
Rev A1, Page 30/35
Selecting the output
At pins INCA and INCB incremental signals are output
with either various interpolation factors or FlexCount
resolutions. Selection is made using parameter INC.
INC
Code
0x00
0x01
0x02
0x03
0x04
0x05
0x06
0x07
Addr. 0x08; bit 6:4
Function
Interpolation factor x1
Interpolation factor x2
Interpolation factor x4
Interpolation factor x8
Interpolation factor x16
iC-Haus digital test
iC-Haus test
FlexCount
A valid Z pulse is only output at pin INCZ when Flex-
Count is enabled (INC = 0x07).
Output in digital test and iC-Haus test modes is de-
scribed in the section on test functions on page 33.
Tristate
The incremental signal pins (INCA/INCB/INCZ) can be
switched to tristate using register bit TRIABZ. After a
power-on TRIABZ is initialized with a 1.
TRIABZ
Code
0
1
Addr. 0x0B; bit 3
Pin function of INCA, INCB, INCZ
Push-pull (incremental signals)
Tristate
Table 42: Incremental output options
Table 43: Incremental output tristate
SHIFT REGISTER OUTPUT
NSL
Latch
CLK
DOUT
MSB
MSB-1
LSB
DIN
NSL
Latch
CLK
DOUT
MSB MSB-1
LSB
DIN
Figure 20: Shift register output
iC-LNB has a shift register for position data readout. In
order to enable this shift register the sensor data chan-
nel for the SPI interface must be disabled by command
ACTIVATE (table 12). After power-on the shift register
in iC-LNB is active and the sensor data channel of the
SPI interface is deactivated.
The position data is output in Gray code or binary code
(depending on parameter NGRAY), with the MSB first.
If pin NSL = 1, the position data is loaded into the shift
register on the first falling edge at pin CLK. Following
this, the data is clocked out on each rising edge at pin
CLK, regardless of the level at pin NSL.
The shift register returns to its idle state on a rising
edge at NSL. This means that the falling edge at NSL
can occur during data transmission and is not time crit-
ical.
RNF is used to select an output level at pin DOUT for
idle state - either idle 1 (high) or the MSB bit in real
time. External data can be read into iC-LNB through
shift register input pin DIN. This is output after the posi-
tion data. The position data readout process is shown
in Figure 20.
The length of the shift register and the number of data
bits used can be selected using parameter SRC.