IC-MH_17 Datasheet, PDF (2/26 Pages) IC-Haus GmbH – 12-BIT ANGULAR HALL ENCODER

iC-MH
12-BIT ANGULAR HALL ENCODER
Rev C2, Page 2/26
DESCRIPTION
The iC-MH 12-bit angular encoder is a position sensor
with integrated Hall sensors for scanning a permanent
magnet. The signal conditioning unit generates con-
stant amplitude sine and cosine voltages that can
be used for angle calculation. The resolution can
be programmed up to a maximum of 4,096 angular
increments per rotation.
The integrated BiSS Interface also enables the posi-
tion data of several networked sensors to be read out.
And the integrated memory can be written embedded
in the data protocol.
The incremental interface with the pins A, B and Z
supplies quadrature signals with an edge rate of up to
8 MHz. Interpolation can be carried out with maximum
resolution at a speed of 120,000 rpm. The position of
the index pulse Z is adjustable.
The commutation interface with the signals U, V and
W provides 120° phase-shifted signals for block com-
mutation. The zero point of the commutation signals
is freely definable in increments of 1.875° over 360°.
The commutation signals are available for EC motors
with 1 and 2 pole pairs.
The RS422-compatible outputs of the incremental
interface and the commutation interface are pro-
grammable in the output current and the slew rate.
In conjunction with a rotating permanent magnet, the
iC-MH module forms a one-chip encoder. The entire
configuration can be stored in the internal parameter
ROM with zapping diodes. The integrated program-
ming algorithm is responsible for the writing of the
ROM structure.
The device described here is a multifunctional iC that contains
integrated BiSS C interface components. The BiSS C process is
protected by patent DE 10310622 B4 owned by iC-Haus GmbH
and its application requires the conclusion of a license (free of
charge).
Download the license at www.biss-interface.com/bua
PACKAGING INFORMATION QFN28 5 mm x 5 mm to JEDEC MO-220-VHHD-1
PIN CONFIGURATION QFN28 5 mm x 5 mm
nc nc nc nc nc nc W
28 27 26 25 24 23 22
PTE 1
NERR 2
VPA 3
VNA 4
SLI
5
MA
6
SLO 7
MH
21 V
20 U
19 VPD
18 VND
17 Z
16 B
15 A
8 9 10 11 12 13 14
nc nc nc nc
nc nc
VZAP
PIN FUNCTIONS
No. Name Function
1 PTE Test Enable Pin
(connect to VNA, VND)
2 NERR Error Output (active low)
3 VPA +5 V Supply Voltage (analog)
4 VNA Ground (analog)
5 SLI BiSS Interface, Data Input
6 MA BiSS Interface, Clock Input
7 SLO BiSS Interface, Data Output
8-11 nc not connected
12 VZAP Zener Zapping Programming Voltage
13,14 nc not connected
15 A
Incremental A (+NU)
16 B
Incremental B (+NV)
17 Z
Index Z (+NW)
18 VND Ground (digital)
19 VPD +5 V Supply Voltage (digital)
20 U
Commutation U (+NA)
21 V
Commutation V (+NB)
22 W Commutation W (+NZ)
23-28 nc not connected
TP Thermal Pad
The Thermal Pad is to be connected to VNA on the PCB. Orientation of the logo ( MH CODE ...) is subject to
alteration.