GS81314LQ19 Datasheet, PDF (33/39 Pages) GSI Technology – 144Mb SigmaQuad-IVe™ Burst of 2 Single-Bank ECCRAM™

GS81314LQ19/37GK-933/800
TAP Controller
The TAP Controller is a 16-state state machine that controls access to the various TAP Registers and executes the operations
associated with each TAP Instruction. State transitions are controlled by TMS and occur on the rising edge of TCK.
The TAP Controller enters the Test-Logic Reset state in one of two ways:
1. At power up.
2. When a logic 1 is applied to TMS for at least 5 consecutive rising edges of TCK.
The TDI input receiver is sampled only when the TAP Controller is in either the Shift-IR state or the Shift-DR state.
The TDO output driver is enabled only when the TAP Controller is in either the Shift-IR state or the Shift-DR state.
TAP Controller State Diagram
1 Test-Logic Reset
0
1
0
Run-Test / Idle
1
Select DR-Scan
0
1
Capture-DR
0
Shift-DR
0
1
1
Exit1-DR
0
Pause-DR
0
1
0
Exit2-DR
1
Update-DR
1
0
1
Select IR-Scan
0
1
Capture-IR
0
Shift-IR
0
1
1
Exit1-IR
0
Pause-IR
0
1
0
Exit2-IR
1
Update-IR
1
0
Rev: 1.02 3/2016
33/39
Specifications cited are subject to change without notice. For latest documentation see http://www.gsitechnology.com.
© 2015, GSI Technology