MB91301A Datasheet, PDF (371/622 Pages) Fujitsu Component Limited. – 32-BIT MICROCONTROLLER

CHAPTER 12 A/D CONVERTER
Table 12.2-6 Settings for A/D Conversion End Channels
ANE2
ANE1
ANE0
End channel
1
x
x
Setting disabled
• Set the same channel as specified by ANS2 to ANS0 to perform one-channel conversion
(single-shot conversion).
• If continuous or stop mode is set, A/D conversion returns to the start channel specified by
ANS2 to ANS0 when the conversion for the channel specified by these bits is completed.
• Define channels ANS and ANE so that the ANS is equal to or less than the ANE.
• These bits are initialized to 000_B by a reset.
Note:
Write 0 when the ANS2 bit is written.
I Setting Example
If the channel settings are ANS=1-channel and ANE=3-channel in single-shot mode:
The operation is performed for input channel (convert channels) to the A/D converter in the
order of 1-channel, 2-channel, and 3-channel.
355