MB82DBS08164D-70L Datasheet, PDF (18/60 Pages) Fujitsu Component Limited. – 128 M Bit (8 M word x 16 bit) Mobile Phone Application Specific Memory

MB82DBS08164D-70L
■ ELECTRICAL CHARACTERISTICS
1. DC Characteristics
Parameter
Symbol
(At recommended operating conditions unless otherwise noted)
Test Conditions
Value
Unit
Min Max
Input Leakage Current
ILI
VSS ≤ VIN ≤ VDD
− 1.0 + 1.0 μA
Output Leakage Current
ILO
0 V ≤ VOUT ≤ VDD,
Output Disable
− 1.0 + 1.0 μA
Output High Voltage Level VOH VDD = VDD (Min), IOH = − 0.5 mA
1.4 ⎯ V
Output Low Voltage Level
VOL IOL = 1 mA
⎯ 0.4 V
VDD Power Down Current
IDDPS
IDDP16
IDDP32
IDDP64
VDD = VDD (Max),
VIN = VDD or VSS,
CE2 = VSS
Sleep
⎯
16 M-bit Partial ⎯
32 M-bit Partial ⎯
64 M-bit Partial ⎯
10 μA
230 μA
260 μA
310 μA
VDD = VDD (Max),
IDDS VIN (including CLK) = VIH or VIL,
CE1 = CE2 = VIH
⎯ 1.5 mA
VDD Standby Current
IDDS1
VDD = VDD (Max),
TA ≤ + 70 °C
VIN (including CLK) = VDD or VSS,
CE1 = CE2 = VDD
TA ≤ + 40 °C
⎯ 400 μA
⎯ 200 μA
IDDS2
VDD = VDD (Max), tCK = tCK (Min) ,
VIN = VDD or VSS, CE1 = CE2 = VDD
⎯ 500 μA
VDD Active Current
IDDA1
IDDA2
VDD = VDD (Max),
VIN = VIH or VIL,
CE1 = VIL and CE2 = VIH,
IOUT = 0 mA
tRC/tWC = Min
tRC/tWC = 1 μs
⎯
35 mA
⎯
5 mA
VDD Burst Access Current
VDD = VDD (Max), VIN = VIH or VIL,
IDDA4 CE1 = VIL and CE2 = VIH, tCK = tCK (Min), BL = 128, ⎯
IOUT = 0 mA
24 mA
Notes : • All voltages are referenced to VSS = 0 V.
• IDD depends on the output termination, load conditions, and AC characteristics.
• After power on, initialization following power-up timing is required. DC characteristics are guaranteed
after the initialization.
• IDDP16, IDDP32, IDDP64, IDDS and IDDS1 might be higher for up to 400 ms after power-up or power down/standby
mode entry.
18
DS05-11454-1E