MC9S08AC16 Datasheet, PDF (306/338 Pages) Freescale Semiconductor, Inc – 8-Bit HCS08 Central Processor Unit (CPU)

Appendix A Electrical Characteristics and Timing Specifications
A.7 Supply Current Characteristics
Table A-7. Supply Current Characteristics
Num C
Parameter
3
1
C ^{Run supply current measured at}
(CPU clock = 2 MHz, f_Bus = 1 MHz)
5
2
C ^{Run supply current measured at}
(CPU clock = 16 MHz, f_Bus = 8 MHz)
Symbol
RI_DD
RI_DD
V_DD
(V)
Typ¹
5 0.988
3 0.570
5 6.84
3
3.5
Max²
1.2⁴
0.770
8⁶
3.70
Unit
Temp
(°C)
mA –40 to 125°C
mA –40 to 125°C
Stop2 mode supply current
3C
S2I
DD
11
0 to 70°C
5 1.36
23
μA –40 to 85°C
130⁴
–40 to 125°C
10.5
0 to 70°C
3 1.05
21
μA –40 to 85°C
110
–40 to 125°C
Stop3 mode supply current
4C
S3I_DD
12
0 to 70°C
5 1.49
28
μA –40 to 85°C
140⁴
–40 to 125°C
11
0 to 70°C
3 1.15
26
μA –40 to 85°C
120
–40 to 125°C
5
C _{RTI adder to stop2 or stop3}⁷
5
300
500
500
nA
–40 to 85°C
–40 to 125°C
S23I_DDRTI
3
300
500
500
nA
–40 to 85°C
–40 to 125°C
5
116
150
180
μA
–40 to 85°C
–40 to 125°C
6
C LVD adder to stop3 (LVDE = LVDSE = 1) _S3IDDLVD
3
90
TBD
160
μA
–40 to 85°C
–40 to 125°C
7
C ^{Adder to stop3 for oscillator enabled8}
(OSCSTEN =1)
S3I_DDOSC
5,3
5
6
TBD
μA ^{–40 to 85°C}
μA ^{–40 to 125°C}
1 _{Typical values are based on characterization data at 25°C unless otherwise stated. See Figure A-5 through Figure A-7 for}
typical curves across voltage/temperature.
2 _{Values given here are preliminary estimates prior to completing characterization.}
3 _{All modules except ADC active, ICG configured for FBE, and does not include any dc loads on port pins}
4 _{Every unit tested to this parameter. All other values in the Max column are guaranteed by characterization.}
5 _{All modules except ADC active, ICG configured for FBE, and does not include any dc loads on port pins}
6 _{Every unit tested to this parameter. All other values in the Max column are guaranteed by characterization.}
7 _{Most customers are expected to find that auto-wakeup from stop2 or stop3 can be used instead of the higher current wait}
mode. Wait mode typical is 560 μA at 3 V with f_Bus = 1 MHz.
8 _{Values given under the following conditions: low range operation (RANGE = 0) with a 32.768kHz crystal, low power mode}
(HGO = 0), clock monitor disabled (LOCD = 1).
MC9S08AC16 Series Data Sheet, Rev. 0
306
PRELIMINARY
Freescale Semiconductor