MC9S12P32CFT Datasheet, PDF (238/566 Pages) Freescale Semiconductor, Inc – S12 Microcontrollers

S12 Clock, Reset and Power Management Unit (S12CPMU)
Several examples of PLL divider settings are shown in Table 7-23. The following rules help to achieve
optimum stability and shortest lock time:
• Use lowest possible f_VCO / f_REF ratio (SYNDIV value).
• Use highest possible REFCLK frequency f_REF.
Table 7-23. Examples of PLL Divider Settings
f_osc REFDIV[3:0] f_REF REFFRQ[1:0] SYNDIV[5:0] f_VCO VCOFRQ[1:0] POSTDIV[4:0] f_PLL
f_bus
off
$00
1MHz
00
$1F
64MHz
01
$03
16MHz 8MHz
off
$00
1MHz
00
$1F
64MHz
01
$00
64MHz 32MHz
off
$00
1MHz
00
$0F
32MHz
00
$00
32MHz 16MHz
4MHz
$00
4MHz
01
$03
32MHz
01
$00
32MHz 16MHz
The phase detector inside the PLL compares the feedback clock (FBCLK = VCOCLK/(SYNDIV+1)) with
the reference clock (REFCLK = IRC1M or OSCCLK/REFDIV+1)). Correction pulses are generated based
on the phase difference between the two signals. The loop filter alters the DC voltage on the internal filter
capacitor, based on the width and direction of the correction pulse, which leads to a higher or lower VCO
frequency.
The user must select the range of the REFCLK frequency (REFFRQ[1:0] bits) and the range of the
VCOCLK frequency (VCOFRQ[1:0] bits) to ensure that the correct PLL loop bandwidth is set.
The lock detector compares the frequencies of the FBCLK and the REFCLK. Therefore the speed of the
lock detector is directly proportional to the reference clock frequency. The circuit determines the lock
condition based on this comparison.
If PLL LOCK interrupt requests are enabled, the software can wait for an interrupt request and for instance
check the LOCK bit. If interrupt requests are disabled, software can poll the LOCK bit continuously
(during PLL start-up) or at periodic intervals. In either case, only when the LOCK bit is set, the VCOCLK
will have stabilized to the programmed frequency.
• The LOCK bit is a read-only indicator of the locked state of the PLL.
• The LOCK bit is set when the VCO frequency is within the tolerance ∆_Lock and is cleared when
the VCO frequency is out of the tolerance ∆_unl.
• Interrupt requests can occur if enabled (LOCKIE = 1) when the lock condition changes, toggling
the LOCK bit.
S12P-Family Reference Manual, Rev. 1.13
238
Freescale Semiconductor