XR17L152 Datasheet, PDF (40/55 Pages) Exar Corporation – 3.3V PCI BUS DUAL UART

áç
DISCONTINUED
XR17L152
3.3V PCI BUS DUAL UART
REV. 1.1.0
MSR[7]: CD Input Status
CD# (active high, logical 1). Normally this bit is the compliment of the CD# input. In the loopback mode this bit
is equivalent to bit-3 in the MCR register. The CD# input may be used as a general purpose input
when the modem interface is not used.
Modem Status Register (MSR) - Write Only
The upper four bits 4-7 of this register sets the delay in number of bits time for the auto RS485 turn around from
transmit to receive.
MSR [7:4]
When Auto RS485 feature is enabled (FCTR bit-5=1) and RTS# output is connected to the enable input of a
RS-485 transceiver. These 4 bits select from 0 to 15 bit-time delay after the end of the last stop-bit of the last
transmitted character. This delay controls when to change the state of RTS# output. This delay is very useful in
long-cable networks. Table 15 shows the selection. The bits are enabled by EFR bit-4.
TABLE 15: AUTO RS485 HALF-DUPLEX DIRECTION CONTROL DELAY FROM TRANSMIT-TO-RECEIVE
MSR[7] MSR[6] MSR[5] MSR[4] DELAY IN DATA BIT(S) TIME
0
0
0
0
0
0
0
0
1
1
0
0
1
0
2
0
0
1
1
3
0
1
0
0
4
9
1
0
1
5
0
1
1
0
6
0
1
1
1
7
1
0
0
0
8
1
0
0
1
9
1
0
1
0
10
1
0
1
1
11
1
1
0
0
12
1
1
0
1
13
1
1
1
0
14
1
1
1
1
15
Scratch Pad Register (SPR)
This is an 8-bit general purpose register for the user to store temporary data. The content of this register is
preserved during sleep mode but becomes 0xFF (default) after a reset or a power off-on cycle.
Feature Control Register (FCTR)
This register controls the UART enhanced functions that are not available on ST16C554 or ST16C654.
40