NS-SERIES Datasheet, PDF (39/57 Pages) Omron Electronics LLC – Programmable Terminals

Expansion Bus Interface
Expansion bus
interface
Any one of the following Units can be mounted to
the expansion bus interface.
Controller Link Interface Unit
NS-CLK21
Controller Link
Video Input Unit
NS-CA001
NTSC/PAL
RGB/Video Input Unit
NS-CA002
NTSC/PAL
RGB output
Note: Video Input Units and RGB Video Input Units cannot be used with some models.
Multi-vendor
NS Series
PLC
Vision
Sensor
Personal computer
RS-232C
port
RS-232C
port
RS-422A
Conversion Unit
CJ1W-CIF11
NS-AL002
Note: A Conversion Unit
is not required to
connect to the
RS-422A/485
serial interface of
the NS15.
RS-422A/485 (See note.)
RS-232C
Screen transfer cable
XW2Z-S002 (Length: 2 m)
Computer Link Unit
Mitsubishi A-series PLC
Function Extension Board or Mitsubishi
FX-series PLC Communications Adapter
Mitsubishi FX-series PLC
Serial Communications Unit
Mitsubishi QnA-series PLC
Serial Communications Unit
Mitsubishi Q-series PLC
Computer Link Module
Yokogawa’s FA-M3(R) Series
SIMATIC S7 HMI Adapter
Siemens S7-300-series PLC
Serial Communications Module
Yaskawa MP-series PLC
Rockwell (Allen-Bradley)
SLC500/Micrologix/ControlLogix/
CompactLogix/PLC-5-series PLC
Modbus device (RTU mode)
Computer Link Unit
Mitsubishi A-series PLC
Function Extension Board or Mitsubishi
FX-series PLC Communications Adapter
Mitsubishi FX-series PLC
Serial Communications Unit
Mitsubishi QnA-series PLC
Serial Communications Unit
Mitsubishi Q-series PLC
Computer Link Module
Yokogawa’s FA-M3(R) Series
Serial Communications Module
Yaskawa MP-series PLC
Rockwell (Allen-Bradley)
PLC-5-series PLC
Modbus device (RTU mode)
Note: Whether an RS-422A or RS-485 connection is supported depends on the device that you are connecting to.
For details, refer to the Connectable Devices page or NS-Series Programmable Terminals HOST CONNECTION MANUAL Multivendor
Connection (Cat.V092).
5