NS-SERIES Datasheet, PDF (14/57 Pages) Omron Electronics LLC – Programmable Terminals

EtherNet/IP
Support for data structures
This special feature is made possible by combining an
OMRON CJ2 PLC with an NS-series PT. The data
structures that you define on the Programming Tool can be
used on the CX-Designer simply by dragging and dropping
them.
Note: An EtherNet/IP connection is required.
For CJ2 Series, CX-Designer version 3.2 or later, and NS system version
8.4 or later are required.
For NJ5, CX-Designer version 3.3 or later, and NS system version 8.5 or
later are required. For NJ3, CX-Designer version 3.4 or later, and NS
system version 8.61 or later are required.Moreover, the multidimensional
array is supported in the combination with NJ.
Definition of the "Motor" Symbol
EtherNet/IP
CJ2/NJ
CX-Designer
Programming Tool
Drag
&
Drop
NS Series
Tag access
A tag is a name given to an address. Tags are managed in
the CJ2 CPU Unit, where they are defined as network
symbols. The common user-defined tag names are used
from Programmable Terminals and host applications to
access memory in a CJ2 CPU Unit without knowing the
physical address.
1. Tag names are managed at the PLC with the CX-Programmer.
Tag name Address
Number_produced D100
2. For example, create screens with tag names without typing the physical address.
Host application
3. All devices will access with Common “Tag”
Number_produced
Number_produced
Accessed by
tag name.
Number_produced
Data links
NS Series
CJ2/NJ
CJ2/NJ
14