NS-SERIES Datasheet, PDF (25/57 Pages) Omron Electronics LLC – Programmable Terminals

Reading the Symbol Table
The symbol table created in the CX-Programmer
during ladder programming can be read into the
CX-Designer by dragging and dropping, so it isn't
necessary to manually data such as input addresses
and I/O comments. Tags (i.e., network symbols) can
also be read into the CX-Designer.
Note: Version 8.0 or higher of the CX-Programmer support tags
(i.e., network symbols).
CX-Designer's
symbol table
Example of Reading the Symbol Table
The symbol table read from the CX-Programmer can
be directly dragged and dropped to the touch switch
and lamp.
(1) Create a switch on the screen.
(3) Allocations for buttons and
lamps can also be checked on
the screen using comments
imported from the
CX-Programmer.
CX-Programmer's
symbol table
Drag
&
Drop
The CX-Programmer's
symbol table can be
dragged and dropped!
Example of Easy Address Allocation
(2) Check the comment then drag-and-drop the symbol from the symbol table to the property list.
Drag
&
Drop
Example of Reading I/O Comments
If Use I/O comment is selected in advance for the Use
symbol text as label, the I/O comments are automati-
cally used as labels when addresses are dragged
and dropped from the symbol table. (If Use symbol
names is selected, the symbol names are used as the
labels.)
Drag
&
Drop
The I/O comment is used as the label.
25