NS-SERIES Datasheet, PDF (29/57 Pages) Omron Electronics LLC – Programmable Terminals

PLC Data Trace
The PLC data trace function can be
used without a computer.
The PLC Data Trace function is built into the PT in
addition to the Ladder Monitor and Device Monitor. A
bit's status and operation can be viewed in a time
chart just by setting the desired PLC bit's address in
the PT. It is also now possible to display word data,
save data in CSV files, and save time chart screens in
BMP files.
Note 1: There are differences between this Data Trace function and the
CX-Programmer's Data Trace function. Refer to the NS-series
Programmable Terminal Programming Manual (Cat. No. V073) for
details.
Note 2: The PLC data trace function cannot be used with the 5.7-inch
model.
Note 3: The PLC data trace function is not supported for connection with a
CP1E PLC.
Data Trace
CS/CJ/CP-series PLC
Operating log
What Was Touched When? can be recorded.
Functionality has been improved with the addition of a log to record operators’ use of the panels. It
is now possible to record and display the time, date, and operation details for buttons (i.e.,
hardware switches) pressed on the control panel in addition to operations on the touch panel. The
operation log can be saved in a CSV file on a Memory Card mounted in the NS-series PT.
Multiple operation log
files can be saved on a
Memory Card with date
and time data.
Switch directly from the user screen
to the log operation display screen.
A comment of up to 32 characters can be set and displayed
for each operation to provide easy-to-understand information
about what type of operation was performed.
For example, with a control panel comprised
of the NS-series PT, hardware switches, and
an emergency
stop button, you can even record and display
operation of the emergency stop button.
Memory Card
Operat_080520_
173000.csv
Operat_080521_
173000.csv
Operat_080522_
173000.csv
The files can be opened in Excel.
29