NS-SERIES Datasheet, PDF (28/57 Pages) Omron Electronics LLC – Programmable Terminals

Comparison ^NEW
The on-site NS screen can be compared with the computer screen.
The comparison function of the CX-Designer enables the following comparison.
CX-Designer project Project in the computer
CX-Designer project NS project
PT Transfer Compare
Comparison
Same
Different
Added
Deleted
Same in screen
Different in screen
Screen added
Screen deleted
Comparison
result
Single Port Multi Access (SPMA)
Note: Communications across network layers can be performed.
Transfer ladder program data to the PLC via
the PT. Perform online editing via the PT.
Computer (Serial/USB) NS-series PT (Ethernet)
PLC (Ethernet or Controller Link) PLC
Transfer screen data via the PLC.
Computer (Serial)
PLC (Ethernet or Controller Link) NS-series PT
Using a USB relay cable greatly improves
debugging at equipment startup.
Use a USB relay cable to enable performing
maintenance from in front of the control panel.
Easy Automatic Connection
A search is automatically made for the PLCs
connected to the PT and the results are displayed
using the automatic online connection function in the
CX-Programmer. Just select a PLC from the list to
connect. This function is also supported for PLCs over
network layers.
CX-Programmer
Keep connected.
CX-Programmer
NS
USB or
Ethernet
The ladder program can be transferred.
Serial connection
(1: N NT Link only)
Ethernet
PLC
Controller Link
Ladder program
Ladder program
Ethernet or Controller Link
Keep connected.
CX-Designer
PLC
USB/Serial or
Ethernet (See note.)
The ladder program can be transferred.
NS
Serial
Note: USB connection is
supported only for CJ2 PLCs.
Screen data
Screen data
Ethernet or Controller Link
Screen data
CX-Programmer
CX-Designer
USB relay cable
(IP65 oil-proof type)
(sold separately:
NS-USBEXT-1M) ^NS
Commercially
available USB
cable
Note 1: SPMA can be used in CS/CJ-series PLCs with lot number
030201 or later.
Note 2: SPMA via a PLC is not supported when a CP-series PLC is
connected. (SPMA via an NS-series PT is supported with a
CP-series PLC.)
Note 3: CX-Programmer version 8.2 and higher support automatic
online connection via the PT. NS system version 8.2 or higher is
28
required.
Automatic
search
PLCs registered to the PT are automatically searched for.
Make the connection simply by selecting from the PLC list.