NS-SERIES Datasheet, PDF (31/57 Pages) Omron Electronics LLC – Programmable Terminals

“Find Back”, “Find Next”, useful Function Supported by the NS-series.
Reduced Time to Investigate Which Output or Input Is Causing the Problem.
Function
Find the address at specified by the cursor.
Find the output from the input bit or find the
input bit from the output at the cursor.
Return to the previous search position.
Operation with NS-series PT.
Next
Double-click
Back
CX-Programmer
“N” Key
“Space” Key
“B” Key
2.Is this input the cause?
What output corresponds
to this input?
4.Which of these two
inputs is the cause? Let’s
look at CIO 21.00 first.
1.Why is this output
not turning ON?
3.Why is this
output not turning ON?
6.So is it input CIO
21.01 after all?
Yes, the
problem
is here!
Force-setting and force-resetting are possible
Locations that have been force-set are displayed in pink and can be checked at a
glance.
1.Select the input bit for which the output will be forced ON.
5.There’s no problem
with input CIO 21.00.
Let’s go back to the
previous program section.
Back
2. Select the address
3. Select the Forced Set Option and
by touching the panel.
then press the Update Button.
Change
4. Forced ON
Minor changes in values of timers or counters can be made without Support Software.
Check and Change I/O While You View the Ladder Diagram on the I/O Monitor
Display and change the present value by specifying the address. It is also possible
to force-set/reset bits with the I/O monitor.
Make the selection with
the I/O monitor by touching
the screen.
Changing the present value
of the address selected with
the Change Value Button
Note: The Ladder Monitor function is not supported by the 5.7-inch models.
31