LM3S808 Datasheet, PDF (384/416 Pages) List of Unclassifed Manufacturers – Microcontroller

Electrical Characteristics
19 Electrical Characteristics
19.1
19.1.1
19.1.2
DC Characteristics
Maximum Ratings
The maximum ratings are the limits to which the device can be subjected without permanently
damaging the device.
Note: The device is not guaranteed to operate properly at the maximum ratings.
Table 19-1. Maximum Ratings
Characteristic^a
Symbol Value Unit
Supply voltage range (V_DD)
V_DD 0.0 to +3.6 V
Input voltage
V_IN -0.3 to 5.5 V
Maximum current for pins, excluding pins operating as GPIOs I
100 mA
Maximum current for GPIO pins
I
100 mA
a. Voltages are measured with respect to GND.
Important: This device contains circuitry to protect the inputs against damage due to high-static
voltages or electric fields; however, it is advised that normal precautions be taken to
avoid application of any voltage higher than maximum-rated voltages to this
high-impedance circuit. Reliability of operation is enhanced if unused inputs are
connected to an appropriate logic voltage level (for example, either GND or V_DD).
Recommended DC Operating Conditions
Table 19-2. Recommended DC Operating Conditions
Parameter Parameter Name
Min Nom Max Unit
V_DD Supply voltage
3.0
3.3
3.6
V
V_IH High-level input voltage
2.0
-
5.0
V
V_IL Low-level input voltage
-0.3
-
1.3
V
V_SIH High-level input voltage for Schmitt trigger inputs 0.8 * V_DD -
V_DD
V
V_SIL Low-level input voltage for Schmitt trigger inputs
0
- 0.2 * V_DD V
V_OH High-level output voltage
2.4
-
-
V
V_OL Low-level output voltage
-
-
0.4
V
I_OH High-level source current, V_OH=2.4 V
2-mA Drive 2.0
-
- mA
4-mA Drive 4.0
-
- mA
8-mA Drive 8.0
-
- mA
I_OL Low-level sink current, V_OL=0.4 V
2-mA Drive 2.0
-
- mA
4-mA Drive 4.0
-
- mA
8-mA Drive 8.0
-
- mA
384
October 01, 2007
Preliminary