SI8421AD Datasheet, PDF (11/37 Pages) List of Unclassifed Manufacturers – LOW-POWER, SINGLE AND DUAL-CHANNEL DIGITAL ISOLATORS

Si8410/20/21 (5 kV)
Si8422/23 (2.5 & 5 kV)
Table 2. Electrical Characteristics (Continued)
(V_DD1 = 3.3 V ±10%, V_DD2 = 3.3 V ±10%, T_A = –40 to 125 °C)
Parameter
Symbol Test Condition
Min
Typ
Max Unit
All Models
Output Rise Time
t_r
C_L = 15 pF
—
2.0
4.0
ns
Output Fall Time
t_f
C_L = 15 pF
—
2.0
4.0
ns
Peak Eye Diagram Jitter
t_JIT(PK)
See Figure 6
—
350
—
ps
Common Mode Transient
Immunity
Start-up Time³
CMTI V_I = V_DD or 0 V
20
t_SU
—
45
— kV/µs
15
40
µs
Notes:
1. The nominal output impedance of an isolator driver channel is approximately 50 , ±40%, which is a combination of the
value of the on-chip series termination resistor and channel resistance of the output driver FET. When driving loads
where transmission line effects will be a factor, output pins should be appropriately terminated with controlled
impedance PCB traces.
2. t_PSK(P-P) is the magnitude of the difference in propagation delay times measured between different units operating at
the same supply voltages, load, and ambient temperature.
3. Start-up time is the time period from the application of power to valid data at the output.
Rev. 1.3
11