C8051F340 Datasheet, PDF (219/282 Pages) List of Unclassifed Manufacturers – Full Speed USB Flash MCU Family

C8051F340/1/2/3/4/5/6/7
19. UART1 (C8051F340/1/4/5 Only)
UART1 is an asynchronous, full duplex serial port offering a variety of data formatting options. A dedicated
baud rate generator with a 16-bit timer and selectable prescaler is included, which can generate a wide
range of baud rates (details in Section “19.1. Baud Rate Generator” on page 220). A received data
FIFO allows UART1 to receive up to three data bytes before data is lost and an overflow occurs.
UART1 has six associated SFRs. Three are used for the Baud Rate Generator (SBCON1, SBRLH1, and
SBRLL1), two are used for data formatting, control, and status functions (SCON1, SMOD1), and one is
used to send and receive data (SBUF1). The single SBUF1 location provides access to both the transmit
holding register and the receive FIFO. Writes to SBUF1 always access the Transmit Holding Register.
Reads of SBUF1 always access the first byte of the Receive FIFO; it is not possible to read data
from the Transmit Holding Register.
With UART1 interrupts enabled, an interrupt is generated each time a transmit is completed (TI1 is set in
SCON1), or a data byte has been received (RI1 is set in SCON1). The UART1 interrupt flags are not
cleared by hardware when the CPU vectors to the interrupt service routine. They must be cleared manually
by software, allowing software to determine the cause of the UART1 interrupt (transmit complete or receive
complete). Note that if additional bytes are available in the Receive FIFO, the RI1 bit cannot be cleared by
software.
SYSCLK
Baud Rate Generator
SBRLH1 SBRLL1
Overflow
Timer (16-bit)
EN
Pre-Scaler
(1, 4, 12, 48)
SBCON1
Data Formatting
SMOD1
Control / Status
SCON1
UART1
Interrupt
Figure 19.1. UART1 Block Diagram
TX
Logic
TX1
TX Holding
Register
SBUF1
RX FIFO
(3 Deep)
Write to SBUF1
Read of SBUF1
RX
Logic
RX1
Rev. 0.5
219