LM3S2965_0711 Datasheet, PDF (303/574 Pages) List of Unclassifed Manufacturers – Microcontroller

LM3S2965 Microcontroller
■ No parity
■ FIFOs disabled
■ No interrupts
The first thing to consider when programming the UART is the baud-rate divisor (BRD), since the
UARTIBRD and UARTFBRD registers must be written before the UARTLCRH register. Using the
equation described in “Baud-Rate Generation” on page 299, the BRD can be calculated:
BRD = 20,000,000 / (16 * 115,200) = 10.8507
which means that the DIVINT field of the UARTIBRD register (see page 312) should be set to 10.
The value to be loaded into the UARTFBRD register (see page 313) is calculated by the equation:
UARTFBRD[DIVFRAC] = integer(0.8507 * 64 + 0.5) = 54
With the BRD values in hand, the UART configuration is written to the module in the following order:
1. Disable the UART by clearing the UARTEN bit in the UARTCTL register.
2. Write the integer portion of the BRD to the UARTIBRD register.
3. Write the fractional portion of the BRD to the UARTFBRD register.
4. Write the desired serial parameters to the UARTLCRH register (in this case, a value of
0x0000.0060).
5. Enable the UART by setting the UARTEN bit in the UARTCTL register.
13.4
Register Map
Table 13-1 on page 303 lists the UART registers. The offset listed is a hexadecimal increment to the
register’s address, relative to that UART’s base address:
■ UART0: 0x4000.C000
■ UART1: 0x4000.D000
■ UART2: 0x4000.E000
Note: The UART must be disabled (see the UARTEN bit in the UARTCTL register on page 316)
before any of the control registers are reprogrammed. When the UART is disabled during
a TX or RX operation, the current transaction is completed prior to the UART stopping.
Table 13-1. UART Register Map
Offset Name
Type
0x000 UARTDR
R/W
0x004 UARTRSR/UARTECR R/W
0x018 UARTFR
RO
0x020 UARTILPR
R/W
Reset
0x0000.0000
0x0000.0000
0x0000.0090
0x0000.0000
Description
UART Data
UART Receive Status/Error Clear
UART Flag
UART IrDA Low-Power Register
See
page
305
307
309
311
November 30, 2007
303
Preliminary