DA9063_17 Datasheet, PDF (14/219 Pages) Dialog Semiconductor – System PMIC for Mobile Application Processors

DA9063
System PMIC for Mobile Application Processors
Table 3: Pin Description
Pin
Pin name
Power Manager
A9 nVDD_FAULT
B6 CHG_WAKE
B7 nIRQ
B8 nSHUTDOWN
B9 SYS_EN
B10 PWR1_EN
C3 VDD_IO2
C4 VDD_IO1
C8 GP_FB2
C9 PWR_EN
D3 GPIO7
D5 TP
D9 nRESET
E8 GP_FB1
E9 GPIO11
H9 GP_FB3
J4 nOFF
J7 nONKEY
Alternate
Function
Type
(Table 2)
Description
GPIO12
GPIO8
GPIO10
GPIO9
GPIO13
DO/DIO
DI/PWR
DO
DI
DI/DIO
DI/DIO
PWR
PWR
DO/DI
DI/DIO
DIO
DIO
DO
DO/DIO
DIO
DO/DO
DI
DI
Indication for low supply voltage / GPIO12 /
VDD_MON controlled GPO
Wakeup signal from companion charger to
trigger a start-up and temporary supply voltage
for PMIC (VBUS_PROT in case of an inserted
supply until charger Buck provides power to
VSYS).
Connect to GND if not used.
IRQ line for host
Active-low input from switch or host to initiate
shutdown
Hardware enable of power domain
SYSTEM/GPIO8
Hardware enable of power domain
POWER1/GPIO10 with high power output / input
for power sequencer WAIT ID
Alternate supply I/O voltage
First supply I/O voltage rail
PWR_OK status indicator: all supervised
regulators are in-range / HW input for watchdog
supervision / dual-phase BUCKCORE voltage
sense at output capacitor
Hardware enable of power domain power /
sequencer controlled GPO
Sequencer controlled GPO
Test pin: enables power commander boot mode
and supply pin for OTP fusing voltage
Active low reset for host
Status indication for host of a valid wakeup
event (EXT_WAKEUP) / indicator for on-going
power mode transition (READY) / GPIO13,
regulator HW control
GPIO11 with high power output and blinking
feature
Second 32K oscillator output: OUT32_2 /
VIB_BREAK control signal for vibration motor
driver (LDO8)
Active-low input from error indication line to
initiate fast emergency shutdown
On/off key with optional long press shutdown
Datasheet
CFR0011-120-00
DA9063_2v1
14 of 219
23-Mar-2017
© 2017 Dialog Semiconductor