LUPA-1300_09 Datasheet, PDF (7/32 Pages) Cypress Semiconductor – 1.3MPxl High Speed CMOS Image Sensor

LUPA-1300
Recommended operating conditions
Table 5. Recommended operation conditions
Symbol
Parameter
Typ
Unit
Vdda
Power supply column read out module.
5
V
Vdd
Power supply digital modules
5
V
Vddr
Power supply logic for drivers
5
V
Voo
Power supply output stages
5
V
Vres
Power supply reset drivers
6
V
Vres_ds
Power supply multiple slope reset driver
4.5
V
Vmem_h
Power supply memory element (high level)
6
V
Vmem_l
Power supply memory element (low level)
4.5
V
Vpix
Power supply pixel array
4.5
V
Vstable
Power supply output stages. Decouples noise on the Voo supply from the
5.5
V
output signal.
Notes
2. All parameters are characterized for DC conditions after thermal equilibrium has been established.
3. Unused inputs must always be tied to an appropriate logic level, e.g. either VDD or GND.
4. This device contains circuitry to protect the inputs against damage due to high static voltages or electric fields; however it is recommended that normal precautions
be taken to avoid application of any voltages higher than the maximum rated voltages to this high impedance circuit.
5. All power supplies should be sufficiently decoupled because spikes and drops in the power supplies will be immediately visible in the analog output signals.
Document Number: 38-05711 Rev. *C
Page 7 of 32
[+] Feedback