CS42L51_07 Datasheet, PDF (65/88 Pages) Cirrus Logic – Low Power, Stereo CODEC with Headphone Amp

CS42L51
This bit is used in conjunction with the REPEAT bit to mix a continuous or periodic beep with the analog
output. Note: Re-engaging the beep before it has completed its initial cycle will cause the beep signal to
remain ON for the maximum ONTIME duration. Refer to Figure 15 on page 36 for a description of each con-
figuration option.
Treble Corner Frequency (TREB_CF[1:0])
Default: 00
00 - 5 kHz
01 - 7 kHz
10 - 10 kHz
11 - 15 kHz
Function:
The treble corner frequency is user selectable as shown above.
Bass Corner Frequency (BASS_CF[1:0])
Default: 00
00 - 50 Hz
01 - 100 Hz
10 - 200 Hz
11 - 250 Hz
Function:
The bass corner frequency is user-selectable as shown above.
Tone Control Enable (TC_EN)
Default = 0
0 - Disabled
1 - Enabled
Function:
The Bass and Treble tone control features are active when this bit is enabled.
6.17 Tone Control (Address 15h)
7
TREB3
6
TREB2
5
TREB1
4
TREB0
3
BASS3
2
BASS2
1
BASS1
0
BASS0
Note: The DATA_SEL[1:0] bits in reg09h must be set to ‘01’b to enable function control in this register.
Treble Gain Level (TREB[3:0])
Default: 1000 dB (No Treble Gain)
Binary Code
0000
···
0111
1000
1001
···
1111
Gain Setting
+12.0 dB
···
+1.5 dB
0 dB
-1.5 dB
···
-10.5 dB
DS679F1
65