AT32UC3L0256_14 Datasheet, PDF (770/852 Pages) ATMEL Corporation – Read-modify-write Instructions and Atomic Bit Manipulation

AT32UC3L0128/256
Table 31-26. AVR_RESET Details (Continued)
Instructions
Details
DR Size
Device specific.
DR input value
Device specific.
DR output value
Device specific.
31.5.3.9
CHIP_ERASE
This instruction allows a programmer to completely erase all nonvolatile memories in a chip.
This will also clear any security bits that are set, so the device can be accessed normally. In
devices without non-volatile memories this instruction does nothing, and appears to complete
immediately.
The erasing of non-volatile memories starts as soon as the CHIP_ERASE instruction is selected.
The CHIP_ERASE instruction selects a 1 bit bypass data register.
A chip erase operation should be performed as:
1. Reset the system and stop the CPU from executing.
2. Select the IR Scan path.
3. In Capture-IR: The IR output value is latched into the shift register.
4. In Shift-IR: The instruction register is shifted by the TCK input.
5. Check the busy bit that was scanned out during Shift-IR. If the busy bit was set goto 2.
6. Return to Run-Test/Idle.
Table 31-27. CHIP_ERASE Details
Instructions
Details
IR input value
01111 (0x0F)
IR output value
p0b01
Where b is the busy bit.
DR Size
1 bit
DR input value
x
DR output value
0
31.5.3.10 HALT
This instruction allows a programmer to easily stop the CPU to ensure that it does not execute
invalid code during programming.
This instruction selects a 1-bit halt register. Setting this bit to one halts the CPU. Setting this bit
to zero releases the CPU to run normally. The value shifted out from the data register is one if
the CPU is halted. Before releasing the halt command the CPU needs to be reset to ensure that
it will start at the reset startup address.
The HALT instruction can be used in the following way:
1. Select the IR Scan path.
2. In Capture-IR: The IR output value is latched into the shift register.
3. In Shift-IR: The instruction register is shifted by the TCK input.
4. Return to Run-Test/Idle.
5. Select the DR Scan path.
32145C–06/2013
770