AK4633 Datasheet, PDF (8/82 Pages) Asahi Kasei Microsystems – 16-Bit Mono CODEC with ALC & MIC/SPK-AMP

ASAHI KASEI
[AK4633]
„ Handling of Unused Pin
The unused I/O pins should be processed appropriately as below.
Classification
Pin Name
Setting
Analog
MIC/MICP, BEEP/MICN, MPI, AOUT,
SPP, SPN, VCOC
These pins should be open.
Digital
MCKI, SDTI
FCK, BICK (Note)
These pins should be connected to DVSS.
These pins should be connected to DVSS, or should
be pulled-down/pulled-up by about 100kΩ resister .
MCKO, SDTO
These pins should be open.
(Note) When the AK4633 is used by the slave mode (M/Sbit=“0”), these pins should be connected to DVSS. When the
AK4633 is used by the master mode (M/Sbit=“1”), these pins should be pulled-down or pulled-up by about 100kΩ
resistor.
ABSOLUATE MAXIMUM RATING
(AVSS, DVSS, SVSS=0V; Note 2)
Parameter
Symbol
min
max
Units
Power Supplies: Analog
AVDD
−0.3
4.6
V
Digital
DVDD
−0.3
4.6
V
Speaker-Amp
SVDD
−0.3
4.6
V
|AVSS – DVSS| (Note 3)
∆GND1
-
0.3
V
|AVSS – SVSS| (Note 3)
∆GND2
-
0.3
V
Input Current, Any Pin Except Supplies
IIN
-
±10
mA
Analog Input Voltage (Note 5)
VINA
−0.3
AVDD+0.3
V
Digital Input Voltage (Note 6)
VIND
−0.3
DVDD+0.3
V
Ambient Temperature (powered applied)
Ta
−40
85
°C
Storage Temperature
Tstg
−65
150
°C
Maximum Power Dissipation (Note 4)
Pd
-
650
mW
Note 2. All voltages with respect to ground.
Note 3. AVSS, DVSS and SVSS must be connected to the same analog ground plane.
Note 4. In case that PCB wiring density is 100%. This power is the AK4633 internal dissipation that does not include
power of externally connected speaker.
Note 5. BEEP/MICN, MIC/MICP pins
Note 6. PDN, CSN, CCLK, CDTI, SDTI, FCK, BICK, MCKI pins
WARNING: Operation at or beyond these limits may result in permanent damage to the device.
Normal operation is not guaranteed at these extremes.
MS0447-E-03
-8-
2006/04