Z02215 Datasheet, PDF (64/74 Pages) Zilog, Inc. – Single Chip Modem with Integrated Controller, Data Pump, and Analog Front End

Z02215
Single Chip Modem with Integrated Controller, Data Pump, and AFE
58
Absolute Maximum Ratings
Table 12. Absolute Maximum Ratings
Parameter
Min Max Units
Operating Temperature (T_OPR)
Extended Temperature (T_EXT)
Storage Temperature (T_STG)
Voltage on any Pin with Respect to V_SS
Voltage on V_DD Pin with Respect to V_SS
Voltage on XTAL and RESET Pins with Respect to V_SS
Total Power Dissipation
0
+70 C
–40 85
C
–55 +150 C
–0.6 +7
V
–0.3 +7
V
–0.6
V_DD+1 V
820 mW
Maximum Allowable Current out of V_SS
Maximum Allowable Current into V_DD
Maximum Allowable Current into an Input Pin
140 mA
140 mA
–600 600 µA
Maximum Allowable Current into an Open-Drain Pin
–600 600 µA
Maximum Allowable Output Current Sinked by Any I/O Pin
20
mA
Maximum Allowable Output Current Sourced by Any I/O Pin
20
mA
Notes:
1. This parameter applies to all pins except XTAL pins and where otherwise noted.
2. There is no input protection diode from pin to V_DD and current into pin is limited to ±600 µA
3. Excludes XTAL pins
4. Device pin is not at an output low state
Notes
1
2
3
4
Stresses greater than those listed under Absolute Maximum Ratings may cause
permanent damage to the device. This rating is a stress rating only. Functional
operation of the device at any condition above those indicated in the operational
sections of these specifications is not implied. Exposure to absolute maximum rat-
ing conditions for an extended period may affect device reliability.
Total power dissipation must not exceed 820W for the package. Power dissipation
is calculated as follows:
Total Power Dissipation
= V_DD x [I_DD – (sum of I_OH)]
+ sum of [(V_DD – V_OH) x I_OH]
+ sum of (V_0L x I_0L)
PS001907-0904
Absolute Maximum Ratings