Z51F0811 Datasheet, PDF (47/52 Pages) Zilog, Inc. – The Z51F0811 Evaluation Board contains the following components

Z51F0811 Evaluation Kit
User Manual
40
Appendix B. OCD Driver Installation on
Windows XP Systems
The driver programs for the Z8051 On-Chip Debugger are copied during the software and
documentation installation. On Windows XP systems, ensure that the target side of the
OCD will remain unconnected while you install these drivers. It is important that you
observe the following procedure; do not skip ahead until the OCD drivers are installed.
1. Connect the OCD hardware to the USB port of your PC by connecting the A-Male end
of one of the two USB A (male)-to-Mini-B cables with the host PC’s USB port, and
connect the Mini-B end to the OCD device.
2. After the PC detects the new hardware, it will display the Found New Hardware Wiz-
ard dialog box, shown in Figure 35. Select Install from a list or specific location
(Advanced); then click Next.
Figure 35. The Found New Hardware Wizard Welcome Screen
UM024205-1012
OCD Driver Installation on Windows XP Systems