|
Z51F0811 Datasheet, PDF (22/52 Pages) Zilog, Inc. – The Z51F0811 Evaluation Board contains the following components | |||
|
◁ |
Z51F0811 Evaluation Kit
User Manual
15
Configure the Z8051 OCD and Z51F0811
Evaluation Board
Observe the following procedure to set up and configure the Z8051 On-Chip Debugger
and the Z51F0811 Board.
Caution: Steps number 1 to 4 present the power-up sequence. Carefully follow these steps
to avoid encountering an improper connection or disconnection.
1. Connect the Z8051 On-Chip Debugger (OCD) to the host PCâs USB port.
2. Connect one end of the 10-circuit cable to the Z8051 OCD.
3. Connect the other end of the 10-circuit cable connector to the Z51F0811 Boardâs J1
and J2 connectors. Pin 1 of the cable connector is indicated by a red stripe, as shown
in Figure 12.
Figure 12. Connecting the 10-Circuit Cable to the Board
4. Using the second USB-to-Mini-B cable, connect the standard USB end to the host
PCâs USB port.
5. Connect the other end of this second Mini-B cable to the Z51F0811 Boardâs P1 con-
nector to apply power to the Board. Note that the green LED D4 is ON; see Figure 13.
Figure 14 shows an example of a completed hardware and software setup.
UM024205-1012
Configure the Z8051 OCD and Z51F0811 Evaluation
|
▷ |