Z51F0811 Datasheet, PDF (24/52 Pages) Zilog, Inc. – The Z51F0811 Evaluation Board contains the following components

Z51F0811 Evaluation Kit
User Manual
17
Build and Run the Z51F0811 Demo
Project
Observe the following procedure to build and run the Z51F0811 demo project.
Note: If you plan to use the Keil µVision IDE, please skip to the Using the Keil µVision IDE on a
Demo Project section on page 23.
1. Browse to the following location and double-click the build_sdcc.bat batch file to
build the project:
<Z8051 Installation>\Z8051_<version_number>\samples\Z51F0811\Demo\build_sdcc.bat
Note: Refer to the Z8051 Tools Product User Guide (PUG0033) for additional information about
these project files and Small Device C Compiler (SDCC) development tools.
2. When the build is complete, the command window will prompt the user to press any
key to continue. Proceed by pressing any key on your keyboard; as a result, a hex file
for the demo will be created in the following path:
<Z8051 Installation>\Z8051_<version_number>\samples\Z51F0811\Demo\demo.hex
3. Set up the OCD and Evaluation Board. If you have not already configured these items,
please return to the Configure the Z8051 OCD and Z51F0811 Evaluation Board sec-
tion on page 15.
4. Run the Z8051 OCD software. From the Start menu, navigate to All Programs →
Zilog Z8051 Software and Documentation <version_number> → Zilog Z8051
OCD <version_number>. Once launched, the program will display Connected, as
shown in Figure 15.
Note: If you encounter a message that says Disconnected, return to the Configure the Z8051
OCD and Z51F0811 Evaluation Board section on page 15 to configure the proper power-
up sequence. If the problem persists, Zilog recommends that you review the Z8051 OCD
Driver Installation and FTDI USB-to-UART Driver Installation sections.
UM024205-1012
Build and Run the Z51F0811 Demo Project