W25Q32FV Datasheet, PDF (79/99 Pages) Winbond – 3V 32M-BIT SERIAL FLASH MEMORY WITH DUAL/QUAD SPI & QPI

W25Q32FV
8.2.41 Global Block/Sector Lock (7Eh)
All Block/Sector Lock bits can be set to 1 by the Global Block/Sector Lock instruction. The command
must be issued by driving /CS low, shifting the instruction code “7Eh” into the Data Input (DI) pin on the
rising edge of CLK, and then driving /CS high. A Write Enable instruction must be executed before the
device will accept the Global Block/Sector Lock Instruction (Status Register bit WEL= 1).
Figure 55. Global Block Lock Instruction for SPI Mode (left) or QPI Mode (right)
8.2.42 Global Block/Sector Unlock (98h)
All Block/Sector Lock bits can be set to 0 by the Global Block/Sector Unlock instruction. The command
must be issued by driving /CS low, shifting the instruction code “98h” into the Data Input (DI) pin on the
rising edge of CLK, and then driving /CS high. A Write Enable instruction must be executed before the
device will accept the Global Block/Sector Unlock Instruction (Status Register bit WEL= 1).
Figure 56. Global Block Unlock Instruction for SPI Mode (left) or QPI Mode (right)
- 78 -
Publication Release Date: Sept 16,, 2013
Revision H