W25Q32JVSFIQ-TR Datasheet, PDF (38/78 Pages) Winbond – 3V 32M-BIT SERIAL FLASH MEMORY WITH DUAL, QUAD SPI

W25Q32JV
Set Burst with Wrap (77h)
In Standard SPI mode, the Set Burst with Wrap (77h) instruction is used in conjunction with “Fast Read
Quad I/O” instruction to access a fixed length of 8/16/32/64-byte section within a 256-byte page. Certain
applications can benefit from this feature and improve the overall system code execution performance.
Similar to a Quad I/O instruction, the Set Burst with Wrap instruction is initiated by driving the /CS pin low
and then shifting the instruction code “77h” followed by 24 dummy bits and 8 “Wrap Bits”, W7-0. The
instruction sequence is shown in Figure 28. Wrap bit W7 and the lower nibble W3-0 are not used.
W6, W5
00
01
10
11
W4 = 0
Wrap Around
Wrap Length
Yes
8-byte
Yes
16-byte
Yes
32-byte
Yes
64-byte
W4 =1 (DEFAULT)
Wrap Around Wrap Length
No
N/A
No
N/A
No
N/A
No
N/A
Once W6-4 is set by a Set Burst with Wrap instruction, all the following “Fast Read Quad I/O” instruction
will use the W6-4 setting to access the 8/16/32/64-byte section within any page. To exit the “Wrap Around”
function and return to normal read operation, another Set Burst with Wrap instruction should be issued to
set W4 = 1. The default value of W4 upon power on or after a software/hardware reset is 1.
/CS
CLK
Mode 3
Mode 0
IO₀
IO₁
IO₂
IO₃
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Mode 3
Instruction (77h)
don't
care
don't
care
don't
care
Wrap Bit
Mode 0
X X X X X X w4 X
X X X X X X w5 X
X X X X X X w6 X
XXXXXXXX
Figure 28. Set Burst with Wrap Instruction (SPI Mode only)
- 37 -