TA1310ANG Datasheet, PDF (81/106 Pages) Toshiba Semiconductor – NTSC VIDEO, CHROMA, DEFLECTION, AND DISTORTION COMPENSATION IC (WITH YUV INTERFACE AND ACB)

NOTE
ITEM
SW MODE
SW₃₄ SW₃₈
D₁₈
Horizontal Blanking Pulse
Threshold
ON A
D₁₉ Curve Correction Range
OFF A
TA1310ANG
TEST CONDITIONS (DEF V_CC = 9 V, Ta = 25 ± 3°C, BUS DATA = POWER-ON RESET)
MEASUREMENT METHOD
Decrease the amplitude of #34 (FBP in) from 9 V_p-p.
When AFC2 stops locking, measure the amplitude.
(V_HBLK1)
Increase the amplitude of #34 (FBP in) from 0 Vp-p.
When horizontal blanking is applied to #13 (R in),
measure the amplitude. (V_HBLK2)
Input a signal as shown below to TP38 from TG7. When the voltage is varied from 3 V to 6 V, measure the
phase variation in the #34 (FBP in) waveform.
D₂₀
H Cycle Black Peak
Detection Disable Pulse
OFF A
Threshold of External Black
D₂₁ Peak Detection Disable
Pulse
OFF A
Set the subaddress (01) D₇ to (0), set the subaddress
(05) D₃~D₁ to (010), and set the subaddress (0C) D₀ to
(1).
When a signal as shown at left is input to TP38 from TG7,
measure the #32 (HD out) waveform phase difference
HBP_S and pulse width HBP_W in relation to the #40 (AFC1
FILTER) waveform.
Set the subaddress (02) D₇ to (1).
Increase the voltage from 0 V. When #52 reaches 3.4 V DC, measure the voltage.
81
2005-09-20