English
Language : 

TA1310ANG Datasheet, PDF (80/106 Pages) Toshiba Semiconductor – NTSC VIDEO, CHROMA, DEFLECTION, AND DISTORTION COMPENSATION IC (WITH YUV INTERFACE AND ACB)
TA1310ANG
NOTE
ITEM
D13 Horizontal Output Voltage
Supply Voltage Dependence
D14 of Horizontal Oscillation
Frequency
SW MODE
SW34 SW38
OFF
1)
B
2)
TEST CONDITIONS (DEF VCC = 9 V, Ta = 25 ± 3°C, BUS DATA = POWER-ON RESET)
MEASUREMENT METHOD
Measure the high-level voltage of #35 (H out) (when #35 is connected to GND via a 481-Ω resistor). (VH35)
Measure the low-level voltage of #35 (H out) (when #35 is connected to GND via a 481-Ω resistor). (VL35)
OFF
When the #37 (DEF VCC) voltage is varied from 8.5 V to 9.5 V, measure the variation in the #35 (H out) oscillation frequency.
B
Temperature Dependence of
D15 Horizontal Oscillation
Frequency
OFF
B When the temperature is varied through the range −20°C to +60°C, measure the variation in the #35 (H out) oscillation frequency.
When a signal as shown at left is input to TP38 from TG7,
measure the phase difference of the #34 (FBP in) waveform
in relation to the #40 (AFC1 FILTER) waveform (SPH1). Also
measure the phase difference of the #40 waveform in relation
to the center of the input horizontal sync signal (SPH2).
D16 Horizontal Sync Phase
OFF A
D17
Horizontal Picture Phase
Adjustment Range
OFF A
Under the above conditions, when the subaddress (0B) D7 to
D3 are varied from (00000) to (11111), measure the phase
variation in the #34 (FBP in) waveform.
80
2005-09-20