English
Language : 

TA1310ANG Datasheet, PDF (54/106 Pages) Toshiba Semiconductor – NTSC VIDEO, CHROMA, DEFLECTION, AND DISTORTION COMPENSATION IC (WITH YUV INTERFACE AND ACB)
TA1310ANG
NOTE
ITEM
A5
RGB Output Half-Tone
Characteristics
A6 RGB Output Amplitude
A7
RGB Output Relative
Amplitude
SW6
C
or
B
SW MODE
SW45 SW52 SW53
1)
2)
B
A
A 3)
4)
5)
(#16 VCC = 9 V, #37 VCC = 9 V, #51 VCC = 5 V, Ta = 25 ± 3°C)
MEASUREMENT METHOD
Input a rainbow signal (signal C-1) to the chroma input pin (TP45).
Burst : chroma = 200 mVp-p : 200 mVp-p.
Now set as follows :
Unicolor
Brightness
Color
Relative phase amplitude
: maximum (subaddress (00H), data (3F))
: maximum (subaddress (01H), data (7F))
: center (subaddress (02H), data (40))
: standard (subaddress (12H), data (00)).
Measure the amplitudes vRo, vGo, and vBo of the R output pin (TP13), the G output pin (TP14), and the B output pin
(TP15).
Set SW6 to B and repeat the test in 3) above. Measure the amplitudes vRH, vGH, and vBH.
Calculate the half-tone characteristics vRHo, vGHo, and vBHo by the following formulas.
vRHo
=
20Log
vRH
vRo
v GHo
=
20Log
v GH
v Go
vBHo
=
20Log
vBH
vBo
1) Input a rainbow signal (signal C-1) to the chroma input pin (TP45).
Burst : chroma = 200 mVp-p : 200 mVp-p.
2) Now set as follows :
Unicolor : maximum (subaddress (00H), data (3F))
Brightness : maximum (subaddress (01H), data (7F))
Color
: center (subaddress (02H), data (40)).
3) Switch the relative phase amplitude (subaddress (12H)) and measure the amplitudes (peak values) of the RGB outputs
C
B
A
A
(TP13, TP14, TP15) according to the table below.
Subaddress (12H) data
TP13
TP14
TP15
STD (00)
DVD (40)
TSB (80)
DTV (C0)
vRSTD
vRDVD
vRTSB
vRDTV
vGSTD
vGDVD
vGTSB
vGDTV
vBSTD
vBDVD
vBTSB
vBDTV
1) Using the values obtained in A06 above, calculate the relative amplitudes by the following formulas.
C
B
A
A
vRB ∗ ∗ ∗
=
vR∗∗∗
vB∗∗∗
vGB =
v G∗∗∗
vB∗∗∗
Note 1: Where the bus data are not specified, set the preset value.
Note 2: Ensure the sync signal is always input to TP38 (SYNC IN).
54
2005-09-20