TA1310ANG Datasheet, PDF (70/106 Pages) Toshiba Semiconductor – NTSC VIDEO, CHROMA, DEFLECTION, AND DISTORTION COMPENSATION IC (WITH YUV INTERFACE AND ACB)

TA1310ANG
NOTE
ITEM
S₀₃
T₃₉ Analog OSD Output Level
A
T₄₀
Analog OSD Mode On
Voltage
A
T₄₁
Analog OSD Mode Transfer
Characteristics
A
T₄₂ RGB Output Self-Diagnosis A
(TEST CONDITIONS V_CC = 5 V and 9 V, Ta = 25 ± 3°C)
SW MODE & SUB ADDRESS & DATA
S₀₄ S₀₅ S₀₆ S₀₇ S₀₈ S₀₉ S₁₀ S₅₄
MEASUREMENT METHOD
1) When 0V (DC) is input from an external power supply to pin 7, when 7.5
V is input to pin 7, and when no external voltage is applied to pin 7,
measure the picture period amplitude of pin 13.
A
A OFF A
A
A OFF C
(V_OSD1R, V_OSD2R, V_OSD3R)
2) As in step 1) above, input to pin 8 and measure pin 14, then input to pin 9
and measure pin 15.
(V_OSD1G, V_OSD2G, V_OSD3G)
(V_OSD1B, V_OSD2B, V_OSD3B)
1) Input signal 1 (f = 100 kHz, picture period amplitude = 0.2 V_p-p) to pin 7.
A
A OFF B
A
A
OFF
C
2) Apply an external power supply to pin 10. Gradually increase the voltage
from 0 V.
3) When signal 1 is output to pin 13, measure the pin 10 voltage.
1) Apply 2.5 V from an external power supply to pins 7, 8, and 9.
2) Input signal 4 (signal amplitude = 4.5 V_p-p) to pin 10.
3) Measure the switching transfer characteristics of pins 13, 14, and 15
A
A OFF A
A
A OFF C
according to diagram T-2.
4) Using the data obtained from the above measurements, calculate the
maximum axis difference between the rising and falling edge of the
transfer delay time.
1) Set the bus control data to read mode and reset.
2) Set to read mode again.
3) Check that the read mode parameter (RGB-OUT) is 0 (error).
A
A OFF A
A
A OFF A _{4) Measure the voltage of pin 54 and apply that voltage +0.7 V to pin 53}
using an external power supply.
5) Set to read mode again.
6) Check that the read mode parameter (RGB-OUT) is 1 (OK).
70
2005-09-20