DRV2510-Q1 Datasheet, PDF (9/32 Pages) Texas Instruments – DRV2510-Q1 3-A Automotive Haptic Driver for Solenoids and Voice Coils with Integrated Diagnostics

www.ti.com
OUT+
OUT-
OUT+ - OUT- 0 V
Solenoid Current 0 A
OUT+
OUT-
No Output
DRV2510-Q1
SLOS919A – JUNE 2016 – REVISED JUNE 2016
Positive Output
OUT+ - OUT- 0 V
Solenoid Current 0 A
OUT+
OUT-
OUT+ - OUT- 0 V
Negative Output
Solenoid Current 0 A
Figure 5. BD Mode Modulation
7.3.3 Designed for low EMI
The DRV2510-Q1 device design has minimal parasitic inductances due to the short leads on the package. This
dramatically reduces EMI that results from current passing from the die to the system PCB. The design
incorporates circuitry that optimizes output transitions that causes EMI. Follow the recommended design
requirements in the Design Requirements section.
7.3.4 Device Protection Systems
The DRV2510-Q1 device features a complete set of protection circuits carefully designed to protect the device
against permanent failures due to shorts, over-temperature, over-voltage, and under-voltage scenarios. The INTZ
pin signals if an error is detected.
Additionally, the DRV2510-Q1 device is not damaged by adjacent pin to pin shorts.
Copyright © 2016, Texas Instruments Incorporated
Product Folder Links: DRV2510-Q1
Submit Documentation Feedback
9