CC3220MOD Datasheet, PDF (48/82 Pages) Texas Instruments – SimpleLink Wi-Fi CERTIFIED Wireless Module Solution

CC3220MOD
SWRS206 – MARCH 2017
www.ti.com
• Fully programmable serial interface characteristics:
– 5, 6, 7, or 8 data bits
– Generation and detection of even, odd, stick, or no-parity bits
– Generation of 1 or 2 stop-bits
• RTS and CTS hardware flow support
• Standard FIFO-level and End-of-Transmission interrupts
• Efficient transfers using µDMA:
– Separate channels for transmit and receive
– Receive single request asserted when data is in the FIFO; burst request asserted at programmed
FIFO level
– Transmit single request asserted when there is space in the FIFO; burst request asserted at
programmed FIFO level
• System clock is used to generate the baud clock.
5.14.3.9 SD Host
CC3220MODx provides an interface between a local host (LH), such as an MCU and an SD memory card,
and handles SD transactions with minimal LH intervention.
The SD host does the following:
• Provides SD card access in 1-bit mode
• Deals with SD protocol at the transmission level
• Handles data packing
• Adds cyclic redundancy checks (CRC)
• Start and end bit
• Checks for syntactical correctness
The application interface sends every SD command and either polls for the status of the adapter or waits
for an interrupt request. The result is then sent back to the application interface in case of exceptions or to
warn of end-of-operation. The controller can be configured to generate DMA requests and work with
minimum CPU intervention. Given the nature of integration of this peripheral on the CC3220x platform, TI
recommends that developers use peripheral library APIs to control and operate the block. This section
emphasizes understanding the SD host APIs provided in the peripheral library of the CC3220x Software
Development Kit (SDK).
The SD Host features are as follows:
• Full compliance with SD command and response sets, as defined in the SD memory card
– Specifications, v2.0
– Includes high-capacity (size >2 GB) cards HC SD
• Flexible architecture, allowing support for new command structure.
• 1-bit transfer mode specifications for SD cards
• Built-in 1024-byte buffer for read or write
– 512-byte buffer for both transmit and receive
– Each buffer is 32-bits wide by 128-words deep
• 32-bit-wide access bus to maximize bus throughput
• Single interrupt line for multiple interrupt source events
• Two slave DMA channels (1 for TX, 1 for RX)
• Programmable clock generation
• Integrates an internal transceiver that allows a direct connection to the SD card without external
transceiver
• Supports configurable busy and response timeout
48
Specifications
Submit Documentation Feedback
Product Folder Links: CC3220MOD
Copyright © 2017, Texas Instruments Incorporated