TL16PNP200 Datasheet, PDF (1/23 Pages) Texas Instruments – STANDALONE PLUG-AND-PLAY (PnP) CONTROLLER

TL16PNP200
STANDALONE PLUGĆANDĆPLAY (PnP) CONTROLLER
D PnP Card Autoconfiguration Sequence
Compliant
D Satisfies All Requirements for Qualifying
for the Windows 95 Logo
D Supports up to Five Logical Devices
D 24-Bit Memory Address Decoding and
16-Bit I/O Address Decoding With
Programmable (1, 2, 4, 8, 16, 32, 64)
I/O Block Size
D Device Interrupt Mapping to Any of the 11
Interrupt Request (IRQ) Signals on Industry
Standard Architecture (ISA) Bus
D Direct Memory Access (DMA) Support For
Two Logical Devices with Configurable
DMA Channel Connection
D Configurable OEN Signals That Can Be
Used to Enabled Logical Device
Transceivers
SLLS229A − NOVEMBER 1995 − REVISED APRIL 1996
D Simple 3-Terminal Interface to Serial
EEPROM 2K/4K ST93C56/66 or Equivalent
for Resource Data Storage and Power-Up
Defaults, As Well As General
Board-Specific Data
D Default Configuration Loading and
Activation Upon Power-up for Non-PnP
Systems
D Two Modes of Operation That Satisfy A
Wide Range of Applications
D Direct Connection to ISA/AT Bus Without
Need for Buffers
D 5-V Power Supply Operation
D Available in 80-pin PQFP
description
The TL16PNP200 is an ISA plug-and-play (PnP) controller that provides autoconfiguration capability to ISA
cards according to the ISA PnP 1.0 a specification. It interfaces to a serial EEPROM where card resource
requirements and power-up defaults are stored. On power up, the controller loads the default configuration from
the EEPROM making it ready for operation (non-PnP systems) or to be configured by the PnP configuration
process (PnP-capable systems). During configuration mode, the PnP autoconfiguration process reads the card
resource requirements, configures the card by writing to the TL16PNP200 configuration registers, activates the
device, and removes it from the configuration mode. Thereafter, the TL16PNP200 routes all ISA transactions
between the card and the ISA bus. The TL16PNP200 operates in one of two modes. In mode 0, the device
supports two logical devices with memory, I/O, interrupt, and DMA resources for each device. In mode 1, the
device supports five logical devices with I/O and interrupt resources for all logical devices and DMA resources
for two of the five logical devices; there is no memory support in mode 1. The TL16PNP200 provides interface
signals to allow on-board logic access to the serial EEPROM.
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
Windows 95 is a trademark of Microsoft Corporation .
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of Texas Instruments
standard warranty. Production processing does not necessarily include
testing of all parameters.
Copyright  1996, Texas Instruments Incorporated
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265
• POST OFFICE BOX 1443 HOUSTON, TEXAS 77251−1443
1