|
MSP430F5510_17 Datasheet, PDF (1/118 Pages) Texas Instruments – Mixed-Signal Microcontrollers | |||
|
Product
Folder
Sample &
Buy
Technical
Documents
Tools &
Software
Support &
Community
MSP430F5510, MSP430F5509, MSP430F5508
MSP430F5507, MSP430F5506, MSP430F5505, MSP430F5504
MSP430F5503, MSP430F5502, MSP430F5501, MSP430F5500
SLAS645J â JULY 2009 â REVISED APRIL 2015
MSP430F5510, MSP430F550x Mixed-Signal Microcontrollers
1 Device Overview
1.1 Features
1
⢠Low Supply-Voltage Range:
3.6 V Down to 1.8 V
⢠Ultra-Low-Power Consumption
â Active Mode (AM)
All System Clocks Active
⢠195 µA/MHz at 8 MHz, 3 V, Flash Program
Execution (Typical)
⢠115 µA/MHz at 8 MHz, 3 V, RAM Program
Execution (Typical)
â Standby Mode (LPM3)
⢠Real-Time Clock (RTC) With Crystal,
Watchdog, and Supply Supervisor
Operational, Full RAM Retention, Fast
Wakeup:
1.9 µA at 2.2 V, 2.1 µA at 3 V (Typical)
⢠Low-Power Oscillator (VLO), General-
Purpose Counter, Watchdog, and Supply
Supervisor Operational, Full RAM Retention,
Fast Wakeup:
1.4 µA at 3 V (Typical)
â Off Mode (LPM4)
Full RAM Retention, Supply Supervisor
Operational, Fast Wakeup:
1.1 µA at 3 V (Typical)
â Shutdown Mode (LPM4.5)
0.18 µA at 3 V (Typical)
⢠Wakeup From Standby in Less Than 5 µs
⢠16-Bit RISC Architecture, Extended Memory, up to
25-MHz System Clock
⢠Flexible Power-Management System
â Fully Integrated LDO With Programmable
Regulated Core Supply Voltage
â Supply Voltage Supervision, Monitoring, and
Brownout
⢠Unified Clock System
â FLL Control Loop for Frequency Stabilization
â Low-Power Low-Frequency Internal Clock
Source (VLO)
â Low-Frequency Trimmed Internal Reference
Source (REFO)
1.2 Applications
⢠Analog and Digital Sensor Systems
⢠Data Loggers
â 32-kHz Watch Crystals (XT1)
â High-Frequency Crystals up to 32 MHz (XT2)
⢠16-Bit Timer TA0, Timer_A With Five
Capture/Compare Registers
⢠16-Bit Timer TA1, Timer_A With Three
Capture/Compare Registers
⢠16-Bit Timer TA2, Timer_A With Three
Capture/Compare Registers
⢠16-Bit Timer TB0, Timer_B With Seven
Capture/Compare Shadow Registers
⢠Two Universal Serial Communication Interfaces
(USCIs)
â USCI_A0 and USCI_A1 Each Support:
⢠Enhanced UART Supports Auto-Baudrate
Detection
⢠IrDA Encoder and Decoder
⢠Synchronous SPI
â USCI_B0 and USCI_B1 Each Support:
⢠I2C
⢠Synchronous SPI
⢠Full-Speed Universal Serial Bus (USB)
â Integrated USB-PHY
â Integrated 3.3-V and 1.8-V USB Power System
â Integrated USB-PLL
â Eight Input and Eight Output Endpoints
⢠10-Bit Analog-to-Digital Converter (ADC) With
Window Comparator
⢠Comparator
⢠Hardware Multiplier Supports 32-Bit Operations
⢠Serial Onboard Programming, No External
Programming Voltage Needed
⢠Three-Channel Internal DMA
⢠Basic Timer With RTC Feature
⢠Section 3 Summarizes Family Members
⢠For Complete Module Descriptions, See the
MSP430x5xx and MSP430x6xx Family User's
Guide (SLAU208)
⢠Connectivity to USB Hosts
⢠Wireless Headsets
1
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,
intellectual property matters and other important disclaimers. PRODUCTION DATA.
|
▷ |