|
MSP430F533_15 Datasheet, PDF (1/112 Pages) Texas Instruments – Mixed-Signal Microcontrollers | |||
|
Product
Folder
Sample &
Buy
Technical
Documents
Tools &
Software
Support &
Community
MSP430F5338, MSP430F5336, MSP430F5335, MSP430F5333
SLAS721D â AUGUST 2010 â REVISED DECEMBER 2015
MSP430F533x Mixed-Signal Microcontrollers
1 Device Overview
1.1 Features
1
⢠Low Supply Voltage Range: 1.8 V to 3.6 V
⢠Ultra-Low Power Consumption
â Active Mode (AM):
All System Clocks Active:
270 µA/MHz at 8 MHz, 3.0 V, Flash Program
Execution (Typical)
â Standby Mode (LPM3):
Watchdog With Crystal and Supply Supervisor
Operational, Full RAM Retention, Fast Wakeup:
1.8 µA at 2.2 V, 2.1 µA at 3.0 V (Typical)
â Shutdown Real-Time Clock (RTC) Mode
(LPM3.5):
Shutdown Mode, Active RTC With Crystal:
1.1 µA at 3.0 V (Typical)
â Shutdown Mode (LPM4.5):
0.3 µA at 3.0 V (Typical)
⢠Wake up From Standby Mode in 3 µs (Typical)
⢠16-Bit RISC Architecture, Extended Memory, up to
20-MHz System Clock
⢠Flexible Power-Management System
â Fully Integrated LDO With Programmable
Regulated Core Supply Voltage
â Supply Voltage Supervision, Monitoring, and
Brownout
⢠Unified Clock System
â FLL Control Loop for Frequency Stabilization
â Low-Power Low-Frequency Internal Clock
Source (VLO)
â Low-Frequency Trimmed Internal Reference
Source (REFO)
â 32-kHz Crystals (XT1)
â High-Frequency Crystals up to 32 MHz (XT2)
1.2 Applications
⢠Analog and Digital Sensor Systems
⢠Digital Motor Control
⢠Remote Controls
⢠Four 16-Bit Timers With 3, 5, or 7
Capture/Compare Registers
⢠Two Universal Serial Communication Interfaces
(USCIs)
â USCI_A0 and USCI_A1 Each Support:
⢠Enhanced UART Supports Automatic Baud-
Rate Detection
⢠IrDA Encoder and Decoder
⢠Synchronous SPI
â USCI_B0 and USCI_B1 Each Support:
⢠I2C
⢠Synchronous SPI
⢠Integrated 3.3-V Power System
⢠12-Bit Analog-to-Digital Converter (ADC) With
Internal Shared Reference, Sample-and-Hold, and
Autoscan Feature
⢠Dual 12-Bit Digital-to-Analog Converters (DACs)
With Synchronization
⢠Voltage Comparator
⢠Hardware Multiplier Supports 32-Bit Operations
⢠Serial Onboard Programming, No External
Programming Voltage Needed
⢠Six-Channel Internal DMA
⢠RTC Module With Supply Voltage Backup Switch
⢠Table 3-1 Summarizes the Available Family
Members
⢠For Complete Module Descriptions, See the
MSP430x5xx and MSP430x6xx Family User's
Guide (SLAU208)
⢠Thermostats
⢠Digital Timers
⢠Hand-Held Meters
1
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,
intellectual property matters and other important disclaimers. PRODUCTION DATA.
|
▷ |